Table of Contents
Advertisement
Quick Links
Aerovalley Technologies
ACP100-300-2
AUDIO CONTROL PANEL
INSTALLATION MANUAL
Revision 01
June 2013
Aerovalley Technologies
Lot 100 Green Valley Road
Telephone:
(08) 8390 1222
Norton Summit
Facsimile:
(08) 8390 1322
South Australia
Email: admin@aerovalleytechnologies.com
AUSTRALIA 5136
Web: www.aerovalleytechnologies.com
Advertisement
Table of Contents
Summary of Contents for Aerovalley Technologies ACP100-300-2
- Page 1 Aerovalley Technologies ACP100-300-2 AUDIO CONTROL PANEL INSTALLATION MANUAL Revision 01 June 2013 Aerovalley Technologies Lot 100 Green Valley Road Telephone: (08) 8390 1222 Norton Summit Facsimile: (08) 8390 1322 South Australia Email: admin@aerovalleytechnologies.com AUSTRALIA 5136 Web: www.aerovalleytechnologies.com...
-
Page 2: Table Of Contents
ACP100-300-2 Audio Control Panel Installation Manual Revision 01 Table of Contents Section 1 Description and Specifications Purpose of Equipment Features Physical Specifications Environmental Specifications Electrical Specifications Interface Specifications Section 2 Installation Equipment required but not supplied Installation Considerations 2.2.1 Cooling 2.2.2 Equipment Location... -
Page 3: Purpose Of Equipment
ACP100-300-2 Audio Control Panel Installation Manual Revision 01 Section 1 - Description and Specifications 1.1 Purpose of Equipment The ACP100-300 Audio Control Panel is specifically designed to allow the integration of commercial and aircraft radio equipment into one aircraft audio system, using no external interfacing units. The ACP100-300 has daul microphone inputs with adjustable gain, bias, relay keying and sidetone generation. -
Page 4: Physical Specifications
ACP100-300-2 Audio Control Panel Installation Manual Revision 01 Roll over to Mute point – 58dBm. 0.2% typical distortion. Complete isolation of microphones from pre-amp circuits for DC and longitudinal noise. Provision for 2 isolated microphone channels. -
Page 5: Interface Specifications
ACP100-300-2 Audio Control Panel Installation Manual Revision 01 1.6 Interface Specifications Audio Output: Level: 10.5VPP into 50. Impedance: >50. Microphone Output: Level: +8dbm (adjustable). Impedance: 150 nominal Frequency Range: 300Hz to 3.5kHz, -6db points. Section 2 – Installation 2.1 Equipment Required: The following equipment is required, but not supplied with the ACP100-300 Audio Control Panel. -
Page 6: Audio/Mic Level Adjustments
ACP100-300-2 Audio Control Panel Installation Manual Revision 01 Section 3 – Installation Procedures 3.1 ACP100-300 Audio/Mic Level Adjustments Copyright 2013© Aerovalley Technologies... - Page 7 ACP100-300-2 Audio Control Panel Installation Manual Revision 01 Copyright 2013© Aerovalley Technologies...
- Page 8 ACP100-300-2 Audio Control Panel Installation Manual Revision 01 3.2 ACP100-300 Outline Drawing Copyright 2013© Aerovalley Technologies...
-
Page 9: Interconnect Drawing
ACP100-300-2 Audio Control Panel Installation Manual Revision 01 3.3 Interconnect Drawing Copyright 2013© Aerovalley Technologies... -
Page 10: Post Installation Checks
ACP100-300-2 Audio Control Panel Installation Manual Revision 01 Note: The installer must establish compliance with the design rule specified in the certification basis of the aircraft and Civil Aviation Order Section 108.34 or the installation requirements pertaining to the regulatory authority for the country of registration, for the aircraft Section 4 –...
Need help?
Do you have a question about the ACP100-300-2 and is the answer not in the manual?
Questions and answers