Download Print this page

DesignTech AutoCommand 20024 Installation Instructions Manual

Remote control car starter with alarm and keyless entry features

Advertisement

Quick Links

Fax On Demand Section 5 - Document #115 - Sheet 1 of 6
DesignTech International, Inc. • 7955 Cameron Brown Court • Springfield, Virginia 22153 USA • 703-866-2000 or 800-337-4468
Congratulations on your purchase of the AutoCommand
to start the car by remote control from the comfort of your home or office in order to cool it down in the summer or heat it up in the winter.
This model includes keyless entry and alarm features.
AutoCommand
®
is for automatic transmission cars only. It is an extremely sophisticated system with multiple built-in safety and security
features.
• Will start your car by remote control, and run the heater, defroster, or air conditioner to warm up or cool down the car.
• Is designed to start the car if it is in park, and only if the hood is closed.
• Has Lock, Unlock and Trunk keyless entry features.
• Has alarm functions including starter kill which becomes active when the doors are locked with the remote control.
• Will attempt to start the car for up to six seconds, but no longer (to avoid damage to the starter motor). Should the car not start, or if it stalls
after starting, the AutoCommand® will make two further attempts to start it.
• Will not let the car be driven without the key in the ignition.
• Shuts itself off automatically after 10 or 15 minutes (programmable) if you forget to come out to your car.
• Will shut off if the brake pedal is pushed, the hood is opened, or the transmission is shifted out of park - unless the key is in the ignition and
in the "run" position.
• Allows you to remove the key while leaving the car running with the doors locked for up to 10 or 15 minutes utilizing the QUICK STOP
option. (See Separate User Tip Sheet)
• Starts the car automatically whenever the temperature drops below 0
Start
TM
option activated. (See Separate User Tip Sheet)
• Has the "Daily Start
TM"
feature which allows the vehicle to be started at the same time the following day. (See Separate User Tip Sheet).
• Is quality engineered, microprocessor controlled, and made in the USA to provide many years of reliable use.
• Comes with a 2 year warranty.
Tools required to install the AutoCommand
Wire Cutters/Strippers
Testmeter
We highly recommend that all connections be soldered for reliability.
AutoCommand
®
Transmitter
Receiver Module
(Model 20028 has 2 transmitters)
Control Harness
6 Power &
(10 position)
Ignition wires
Parts Kit in plastic baggy:
Lock/Unlock/Trunk Harness
Alcohol Pad
WARNING
This car is equipped with a remote control starting device.
Disable before working on car!
AVERTISSEMENT
Ce véhicule est équipé d'un systéme de démarrage a distance. Mettez-le hors
fonction avant d'eflectuer toute opération d'entretien ou de réparation!
On/Off Control Switch
Warning Label
2 Antenna Clips with Adhesive Pads
DesignTech disclaims any liability or responsibility arising out of any inaccuracies of this information or use of this information in installation or otherwise.
©1998 All Rights Reserved
DesignTech International, Inc.
Please Read Completely Before Beginning
®
Remote Car Starter. The AutoCommand
The AutoCommand
®
®
Unit:
Soldering Iron
Pliers
Screwdriver
Drill
Siren
Antenna
(Model 20028 only)
2 Relays with relay harnesses
Shock Sensor
(Model 20028 only)
(Model 20028 only)
30 A Fuse
Plug-in LED
Window Decal
Ring Terminal
Hood Pin Switch Set
2 Cable Ties
Section 5 - Page 17
®
Remote Car Starter system allows you
Remote Car Starter:
o
o
F (-18
C), or if the battery voltage drops below 11 volts with the Cold
Wiring Diagram
Power Harness
Color
Function
Required
Pink
Power (+12V) Input
White
Accessory
Yellow
Starter
Blue
Ignition 1
Green
Ignition 2
Black
Ground
Lock/Unlock/
ON/OFF Switch Jack
Trunk Harness
Control Harness
Color
Function
Type
Required
White/Black
Ignition 3
(-)400mA
No
Brown/White
Alarm Disable (-)400mA
No
Brown
Accessory
(-)400mA
No
Blue
Horn
(-)400mA
No
Yellow
Lights
Relay Output
No
White-Option
Red-Code Learn
LED
Plug-in LED
Color
Function
Type
Required
Orange
Brake
(+)Input
Yes
Violet
Hood
(-)Input
Yes
Green
Tach
(-)Input
No
Red/White
Alarm Input
(-)Input
No
Red/Black
Diesel
(+/-) Input
No
1
DesignTech International, Inc.
V 8.7
TM
Circuit
Type
Yes
Relay output
Yes
Relay output
Yes
Relay output
Yes
Relay output
Maybe
Input
Yes
Coax
Antenna Jack
Shock Sensor Plug
1-800-DESIGNTECH
www.designtech-intl.com

Advertisement

loading

Summary of Contents for DesignTech AutoCommand 20024

  • Page 1 2 Antenna Clips with Adhesive Pads Hood Pin Switch Set 2 Cable Ties DesignTech disclaims any liability or responsibility arising out of any inaccuracies of this information or use of this information in installation or otherwise. DesignTech International, Inc. ©1998 All Rights Reserved 1-800-DESIGNTECH DesignTech International, Inc.
  • Page 2 The vehicle’s wires are found coming off of the key switch. START DesignTech disclaims any liability or responsibility arising out of any inaccuracies of this information or use of this information in installation or otherwise. DesignTech International, Inc. ©1998 All Rights Reserved 1-800-DESIGNTECH DesignTech International, Inc.
  • Page 3 You can however repeat the above steps to learn tach over again at any time. DesignTech disclaims any liability or responsibility arising out of any inaccuracies of this information or use of this information in installation or otherwise. DesignTech International, Inc.
  • Page 4 Ign. 2 not active during crank On/Off switch on -- the red LED will flash once. DesignTech disclaims any liability or responsibility arising out of any inaccuracies of this information or use of this information in installation or otherwise. DesignTech International, Inc.
  • Page 5 (The AutoCommand ® ignition and ac- cessory wires come on). DesignTech disclaims any liability or responsibility arising out of any inaccuracies of this information or use of this information in installation or otherwise. DesignTech International, Inc. ©1998 All Rights Reserved 1-800-DESIGNTECH DesignTech International, Inc.
  • Page 6 PLEASE HAVE MODEL NUMBER (20024/20028) AND DIAGNOSTIC CODES OF (STEP 23) READY BEFORE CALLING TECH SUPPORT DesignTech disclaims any liability or responsibility arising out of any inaccuracies of this information or use of this information in installation or otherwise. DesignTech International, Inc.

This manual is also suitable for:

Autocommand 20028