Vela 2000-2165 Installation And User Manual page 40

30 CineCast HD Version 2.6 Installation and User Manual
4. If the "Digital Signature Not Found" screen appears, click Yes to continue
with the installation.
5. Insert the CD-ROM if you have not already done so. Exit the Autorun setup
screen if it appears.
6. Right click on the "My Computer" icon on the desktop. A drop-down menu
should appear. Highlight "Properties," then click on it.
7. Click on the tab labeled "Hardware."
8. Click on "Device Manager." A screen similar to that of Figure 1-15 appears.
Click on the Action tab, then "Scan for hardware changes."
9. The "Found New Hardware Wizard" will detect the Vela CineCast decoder
type. The "Device Driver Wizard" screen will appear (Figure 1-16). Click Next.
10. Wizard screen "Install Hardware Device Drivers" (Figure 1-17) appears.
Select the radio button "Search for a suitable driver for my device." Click Next.
11. Wizard screen "Locate Driver Files" (Figure 1-18) will appear. Check
"Specify a Location," then click Next.
12. A message box (Figure 1-19) will appear that will allow you to browse your
computer until you find a driver for the Multimedia controller. Check Browse to
select the device from the following path for the driver.
Drivers\Cinecast\Windows 2000\Cinecast.INF.
Note: When prompted for the CineCast.sys file, the directory path is the same as above.
13. When the Vela Decoder driver installation is complete, a prompt screen
(Figure 1-20) will appear: "Completing the Upgrade Device Driver Wizard." Click
Finish. Close the screens and return to "Device Manager," where the Vela CineCast
decoder should be recognized. Repeat steps 9–14 for each device as needed.
14. When the Vela CineCast driver installation is complete, a prompt screen
(Figure 1-20) will appear: "Completing the Upgrade Device Driver Wizard."
Click Finish. Close screens and return to "Device Manager," where each Vela Cine-
Cast decoder should be recognized,
15. At this time you will receive a "System Settings Change" message box (Figure
1-21). Click Yes to restart the system. If this does not occur, manually reboot your
system. Do not remove the CD-ROM disc during the restart process.
16. The setup screen should pop up after the system restart. If it does not, run
setup.exe from the CD-ROM or click Start > Run.
Proceed with the installation of CineCast system software. See "Installing Cine-
Cast 2.6 Software (Windows 2000)" on page 34.
Software Installation