Attaching To Tractor - King Kutter 999995 Operator's Manual

ATTACHING TO TRACTOR

STEP 1
Attach to tractor's category 1 three point hitch as described in the
Tractor's Operator's Manual.
STEP 2
Determine if the PTO shaft needs to be shortened.
NOTE:
Due to the many variations in the tractor hitch points and dis-
tances between equipment gearbox input shaft and tractor PTO
out put shafts, some combinations may require PTO shafts to be
shortened as described by the following steps.
STEP 3
Raise and lower rotary tiller in order to locate the shortest distance be-
tween equipment gearbox input shaft and tractor PTO output shaft.
With the rotary tiller in the shortest distance position shut down the trac-
tor and SECURELY BLOCK ROTARY TILLER IN POSITION.
WARNING: IF TILLER IS RAISED UP SO THAT PTO SHAFT IS AT AN ANGLE
SHARPER THAN 35 DEGREES PTO MUST BE STOPPED!
16
WARNING
Never stand between
tractor and rotary tiller
while backing up tractor
to the hitch.