Advertisement
NOTES ON INSTALLING AND USING YOUR NEW BULLET SPEAKERS
◆ For best performance, provide 100W-RMS at 4 Ohm to each speaker.
◆ Regularly check all hardware to make sure it is tight.
◆ Although the speakers are weather resistant and designed for outdoor use,
do not spray directly into the grill with high-pressure water.
◆ Handle the speakers with care as the aluminum enclosures can be damaged if dropped.
Please contact a marine wiring specialist if you need assistance.
We have provided the most complete information we have found within this document.
OM-AddictBullitSpeaker.indd 1
BULLET SPEAKERS
INSTALLATION GUIDE
Check WWW.JOBESPORTS.COM for other languages of this manual
12-2008
09-12-2008 09:13:47
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Jobe Sports Addict Bullet Speakers
-
Page 1: Installation Guide
12-2008 BULLET SPEAKERS INSTALLATION GUIDE Check WWW.JOBESPORTS.COM for other languages of this manual NOTES ON INSTALLING AND USING YOUR NEW BULLET SPEAKERS ◆ For best performance, provide 100W-RMS at 4 Ohm to each speaker. ◆ Regularly check all hardware to make sure it is tight. ◆ Although the speakers are weather resistant and designed for outdoor use, do not spray directly into the grill with high-pressure water. ◆ Handle the speakers with care as the aluminum enclosures can be damaged if dropped. Please contact a marine wiring specialist if you need assistance. We have provided the most complete information we have found within this document. OM-AddictBullitSpeaker.indd 1 09-12-2008 09:13:47... - Page 2 Running Wires Through The Tower The following is specific to running wires on a Addict Tower, otherwise consult your tower installation manual or provider for instructions on running wire inside your tower. When you add speakers or lights to your Addict Tower, you can hide the wires inside of the legs of the tower as well as in the straight cross bar of the top section. Most of our Addict towers are already pre drilled. If not you have to drill a hole yourself. Since the mating parts insert 0,5” inside each end of the rear leg you can drill 1” away from the weld lines. The hole size will depend on what size wire you are running and how many items you need to wire. The maximum hole size we recommend is 0,5” but normally smaller is all that is needed. Care and Maintenance Be sure to check and tighten all fasteners and connections prior to every use. II. Be cautious when towing or driving under obstacles, low hanging structures or trees with your towers on. III. Use soap and water or general cleaners to clean. Avoid abrasive materials that might scratch the finish. IV. Always rinse speakers after contact with salt (brackish) water. JOBE Addict Bullet Speakers Warranty Jobe Sports Europe warrants this product (not including other 3rd party accessories) against manufacturers defects. Anodizing and powder coated surfaces as well as all hardware corrosion are specifically excluded as their care and use cannot be controlled by Jobe Sports Europe. Any modifications or improper use shall void this warranty. Jobe Sports Europe is not responsible for personal injury or damage to the boat caused by the use of this tower. JOBE’s obligation under this warranty shall not include any transportation charges or costs of installation or any liability for direct, indirect or consequential damages resulting from delay or improper installation. No dealer, retailer or manufacturer is the agent of Jobe Sports Europe and may not assume for Jobe Sports Europe any liability in connection with this warranty. This warranty is in lieu of all. Distributed by: Jobe Sports Europe Heerewaardensestraat 30 6624 KK Heerewaarden The Netherlands WWW.JOBESPORTS.COM OM-AddictBullitSpeaker.indd 2 09-12-2008 09:13:47...
Need help?
Do you have a question about the Addict Bullet Speakers and is the answer not in the manual?
Questions and answers