Rhodan HDGPS ANCHOR+BB - 8048 Owner's Manual page 9

RECALLING A STORED ANCHOR SITE
From any mode, while holding down the "A" button, press and release the
appropriate directional button. The "A" button can then be released and
your boat will navigate in a straight line directly to that location and anchor
at the selected, previously recorded site.
The unit will "beep a tune" (multiple consecutive beeps) to indicate
that the anchor site has been successfully retrieved.
The unit will emit two "growls" and exit if the memory location
is empty or the boat is not within 1 mile of a memorized location.
When recalling a stored anchor site if you hold the buttons for more than
5 seconds you will over-write that existing memory location with the
boat's present location, erasing it.
The system will calculate a beeline to the selected anchor site. Make
sure there are no obstructions between you and the anchor site prior to
recalling a location.
RECALLING LAST ANCHOR SITE
From any mode, press and hold the "A" button for 5 seconds. The "A"
button can then be released and your boat will navigate directly to the last
anchor location used.
The unit will "beep a tune" (multiple consecutive beeps) to indicate
that the anchor site has been successfully retrieved.
The unit will emit two "growls" and exit if there is no active last
memory location or the boat is not within 1 mile of the previous location.
CUSTOMER SERVICE: 1-888-434-7726
w w w . r h o d a n m a r i n e . c o m
9