Summary of Contents for Brother, Brother & Sons LEDHEIMER
Page 1
L E D H E I M E R USER MANUAL BROTHER, BROTHER & SONS ApS...
Page 2
LEDHEIMER USER MANUAL INTRO Brother, Brother & Sons ApS The information in this manual is subject to change without notice. Go to www.brothers-sons.dk for the latest version. Brother, Brother & Sons ApS assumes no responsibility for any errors or inaccuracies that may appear in this manual.
LEDHEIMER USER MANUAL SAFETY Safety Notice: It is important to read ALL safety information and instructions in this manual before install- ing and operating the product described. Safety symbol used in this manual: WARNING: Potential injury or damage to persons or product.
LEDHEIMER USER MANUAL PRODUCT OVERVIEW PowerCon IN DMX IN DMX OUT PowerCon OUT 238,70 mm / 9,39” 284 mm / 11,18” 185,50 mm / 6,24” 200 mm / 7,87” 233,65 mm / 9,20” 185,50 mm / 6,24” WWW.BROTHERS-SONS.DK...
LEDHEIMER USER MANUAL YOKE ARRAY ASSEMBL Y Sidemount Place the sidemounts on the top and side or bottom and side (refer to illustration above). Insert ballpins in the the positions as shown. Note that, when inserting ballpins to interlock two Ledheimers, only one ballpin is used on the side in question and always the one closet to the front.
Page 8
LEDHEIMER USER MANUAL YOKE ARRAY ASSEMBL Y Mount each mounting plate using 4 hex screws and 4 Hex screw washers as illustrated. Washer But do not tighten them yet. Mounting plate WWW.BROTHERS-SONS.DK...
Page 9
LEDHEIMER USER MANUAL YOKE ARRAY ASSEMBL Y Before tightening the screws that connects the fixtures to the mounting plates, you will need to position the fixtures accord- ing to the illustrations and your desired setup. Parallel Angled Parallel Angled WWW.BROTHERS-SONS.DK...
Page 10
LEDHEIMER USER MANUAL INSTALLATION Do not operate the product if the ambient temperature exceeds 40° C / 104°F Provide a minimum clearance of 0,1m (4 in.) around fans and air vents. This fixture must be connected to ground. This fixture is for indoor use only.
LEDHEIMER USER MANUAL AC Power This fixture must be connected to ground. Electrical: AC Power: 100 – 240 V nominal, 50/60 Hz Powersupply: Electronic switchmode Max power consumption: 132 w DMX Data link This product uses a 5-pin XLR for dmx input and output.
Page 12
LEDHEIMER USER MANUAL Software vers. 1_3_00 Linear curve on Indicator Response fast indicator Strobe on Indicator 8 8 8 8 8 8 8 bit Indicator DMX present indicator MENU Open menu / Go back ENTER Select / Confirm Scrolling UP / Increase value...
LEDHEIMER USER MANUAL Software vers. 1_3_00 SOFTWARE MENU Default values indicated by bold font Addr DMX adress value 1 - 512 Resolution 8 bit resolution 16 bit resolution Response Slow (fade between values) Fast (snap between values) Strobe On - (adds 2 strobe channels)
Page 14
LEDHEIMER USER MANUAL Software vers. 1_3_00 SOFTWARE MENU ..continued Default values indicated by bold font Max Fan Maximum fan speed logged. (in RPS) - READOUT ONLY Fan RPS Current fan speed (in RPS) - READOUT ONLY EEProm Developer info LED U...
Page 15
LEDONARDO 1 USER MANUAL FAQ - TROUBLESHOOTING Problem: Possible Cause: Solution: Brother, Brother & Sons ApS - The information in this manual is subject to change without notice. Go to www.brothers-sons.dk for the latest version. WWW.BROTHERS-SONS.DK...
LEDHEIMER USER MANUAL SPECIFICATIONS Physical: Depth: 234 mm / 9,20” Width: 239 mm / 9,39” Height: 284 mm / 11,18” Weight: 4,8 kg / 10,58 lbs Data: DMX Channels: 1 or 2 at 8bit: 2 or 3 at 16bit: Protocol: USITT DMX512-A...