Advertisement
MAINTENANCE
MONTHLY- CLEAN THE THROAT PLATE and CHECK THE DOOR SEALS The throat plate (sometimes called a baffle plate) is the
cast-iron plate inside the roof of the stove, item (9) in the diagram below. It serves to distribute flames towards the sides and top of the
fire and so increase heat output. Remove the plate when the stove is cool to brush off any deposits of soot or ash which might cause a
blocked chimney. Check that the door seals are undamaged, (replacing them if necessary) and that they fully seal against the stove
body. After a period of use the seals can become compressed - if this happens, open the door and lift it upwards to remove, screw in
the hinge supports on the stove body and re-fit the door, repeating this until a tight seal is achieved. The door catch can be adjusted
by unfastening the nut on the back of it and placing washers either in front of or behind the catch itself to move it in or out.
ANNUALLY- SWEEP THE CHIMNEY The entire length of the chimney from stove to outlet should be swept annually, or more often if
smoky fuels are used.
REFURBISHMENT Should the stove body become scratched or dull, repaint it only with heat resistant paint supplied for the purpose
and only when the fire is completely cold. A small jar of paint is supplied with the stove.
NEW PARTS Tiger has been extensively tested for safety - please don't try to modify it and always make sure to obtain genuine spare
parts.
SPARE PARTS
TIG5-1 PLUS Main casing
TIG5-4 Main casing Base
TIG5-6 Main casing Top
TIG5-7 Flue outlet collar
TIG5-8 Flue outlet blank
TIG5-9 Throat plate
TIG5-10 Grate frame
TIG5-11 Front firebar
TIG5-12 Grate
TIG5-14 Door
TIG5-15 Primary air slide
TIG5-16 Airwash plate
TIG5-17 Door inner plate
TIG5-18 Hinge and pin
TIG5-19 Ashpan
TIG5-20 Window
TIG5-21 Glass rope - large
TIG5-22 Glass rope - small
TIG5-23 Door catch assembly
TIG5-24 Operating tool
TIG5-25 Leg
TIG5-26 Brick - rear
TIG5-27 Brick - side left or right
TIG5-28 Fire cement
TIG5-29 Stove black paint
TIG5-30 Screws and fixings pack
TIG5-31 Spiral wire handle- black or silver
The Tiger stove is fully guaranteed for one year from the date of purchase, in addition to your statutory rights.
Designed in England by Glyn Hughes Design. The Tiger Stove is registered at the UK Patent Office 3019213, and is fully protected by
Copyright © and UK Design Right, Glyn Hughes 1999/2005. Assembled in Gao Zhuangzi Village, Tianjin, China from components
manufactured in the USA, UK, Japan and China. The suppliers reserve the right to change any specification without notice. CD&P Act 'right
of recognition' is invoked. Issued a:20/01/11
www.tiger-stoves.com
Distributed in Europe by:
Capital Fireplaces, Unit 12, Henlow Ind Est, Henlow
Camp, Beds SG16 6DS UK
Tel: 01462-813138
Percy Doughty & Co, Imperial Point, Stone Hill Rd,
Farnworth Bolton BL4 9TN UK
Tel: 01204-868-550
4
Advertisement
