Advertisement
3.
4.
EQ CONTROL INDEPEDANT CHANNEL
5.
EFFECT CONTROL INDEPEDANT CHANNEL
6.
LCD DISPLAY USB/SD CONTROL
7.
EFFECTS CONTROLLERS
8.
USB/SD VOLUME CONTROL
9.
MASTER VOLUME CONTROL
10.
MASTER GRAPHIC EQUALIZER CONTROL
11.
12.
AUX (3.5mm) INPUT
13.
14.
15.
INPUT VOLUME CONTROL
Pyle 'PMX' Series Multi Channel Mixers
www.PyleAudio.com
GAIN CONTROL
POWER LED
CD/TAPE: INPUT
REC: OUTPUT
Adjust the volume for the selected channel's signal. It send the signal to the
master mix buss, please remember this function allows the unit to act as a
pre amp (...so if you are using a device that has its own unique volume
control, you will need to perform some volume adjustment and level
matching. Optimal sound performance is achieved when audio distortion is
at a minimum.
Independent channel selection allows equalization effect controls for the
input signal. This gives you the ability to adjust the overall tone of the
selected input. It acts as a cut or boost control, that adds to or diminishes
the sound quality 60Hz 10kHz (+/ 15dB).
Also known as EFFX controls, this is a 'send' control to the reverb buss. It
controls the amount of reverberation added to the selected destination
channel input signal.
Use the digital LCD control panel and touch button to control your
connected flash memory drive. Take music from your computer's media
library, transfer it to your removable memory storage device and let it play
through the mixer. Supports MP3 and WMA music formats.
Take control of the Effects Volume, Effects Echo and Effects Delay. Control
the overall signal level of the effects 'mix' that is received. Delay and Echo
controls allow you to variably adjust the effect interval time. Set this control
lower for shorter Echo times to emulate similar 'doubling' effects while
setting a higher level provides longer effect times for 'stadium like' delay
sound.
Adjust the volume for connected media streaming via USB Flash Memory or
SD Memory Cards
Adjust the volume for the entire mixer and connected devices playing
through the mixer.
(Low Low/Mid Mid Mid/High High), these master EQ controls allow you
to adjust the levels of signal frequencies. 5 Band frequency. graphic EQ
faders put you in control and allow you to achieve optimal sound
performance. Adjust the faders accordingly with different acoustic and
environmental conditions.
This LED will illuminate when the unit is switched on.
Auxiliary input connector jack for connecting devices like MP3 Players,
Smartphones, Tablets, etc.
Use the RCA (L/R) input connector jacks to connect a stereo signal output
device to the mixer. (CD, Tape, Cassette, MP3, Smartphone, Tablet, Mac, PC,
Laptop, etc.)
This signal RCA (L/R) output connector jacks are for connecting an external
device to record from the mixer. Both channels are conformed into mono
for compatibility. The signals are then taken 'pre master' meaning the signal
is without reverb or the master tone section does not include the tape
signal. The connected signal becomes the 'main' bus signal before passing
through the mixer's 'master' level controls and graphic equalizer.
(Impedance: 1k Ohm @ 10dB)
This control adjusts the level of the input signal applied to the CD/TAPE
Input.
Advertisement
