Getting Started - iSP Technologies Theta Owner's Manual

SWEEP FREQUENCY CONTROL
This control works in conjunction with the MID boost/cut control and adjusts the
center frequency of the MID boost or cut signal. At the full counter clockwise setting
the midrange frequency will be at 300Hz, at the full clockwise setting the center
frequency of the midrange will be at 6KHz.
12:00 straight up the SWEEP will not have any effect on the signal since there is no
boost or cut being applied.
TREBLE CONTROL
The TREBLE control adjusts the boost or cut that is applied in the high frequency
portion of the spectrum of PREAMP.
+/-15 decibels.
SETTING THE THETA CONTROLS

GETTING STARTED

It's best to start with a flat response and adjust from that starting point. The THETA can
be used for virtually any sound you are looking for but it will be easiest to dial in your
sound with the controls set flat. The diagram below shows the recommended starting
point.
NOTE: when the MID control is set at
The available TREBLE boost and cut range is