Table of Contents
Advertisement
Memory seats/power mirrors/steering column
This system allows automatic
positioning of the driver seat, power
mirrors, and steering column to two
programmable positions.
The memory seat control is located
on the driver door.
• To program position 1, move the
driver seat, mirrors and steering
column to the desired position
using the associated controls.
Press and hold control button 1 for at least two seconds.
• To program position 2, repeat the previous procedure using control
button 2.
A position can be recalled:
• in any gearshift position if the ignition is not on.
• only in P (Park) or N (Neutral) if the ignition is on.
A memory seat position may be programmed at any time.
The memory positions are also recalled when you press your remote
entry transmitter
(unlock) control (if the transmitter is programmed
to a memory position) or, when you enter a valid personal entry code
that is programmed to a memory position.
To program the memory feature to a remote entry transmitter and for
more information on how to use the keypad, refer to Remote entry
system in the Locks and Security chapter.
Easy entry/exit feature
This feature automatically moves the steering wheel all the way up and
in and moves the driver's seat rearward 2 in (5 cm) when:
• the transmission is in N (Neutral) or P (Park)
• the key is removed from the ignition cylinder or the push button start
system (if equipped) is switched off (refer to Push button start
system in the Driving chapter).
The seat and steering wheel will move to the original position when:
• the transmission is in N (Neutral) or P (Park)
• the key is placed in the ignition cylinder or when the push button
start system (if equipped) is put in accessory mode (refer to Push
button start system in the Driving chapter).
2010 MKS (mks)
Owners Guide, 2nd Printing
USA (fus)
Seating and Safety Restraints
147
Advertisement
Table of Contents
