Copystar FS-2020D Installation Manual

FS-2020D/FS-3920DN/FS-4020DN
Clearance
Make sure that the place of installation meets the following requirements.
300 mm
(11-13/16")
300 mm 100 mm 200 mm
(11-13/16") (3-15/16") (7-7/8")
1

List of Shipped Components

Carefully remove the printer and other items from the box.
Check that nothing is missing against the list of shipped components.
Printer
Toner Container
Waste Toner Box
Power Cord
Plastic Waste Bag
2
Installing the Rear Cover
1
Insert the protrusion at the right of the rear cover into the hole in the printer.
3

Installing the Toner Container and Waste Toner Box

Before you can use the printer for the
first time, you must prepare it by
installing the toner container and waste
toner box.
5
Install the toner container into the
printer.
9
Open the left cover.
600 mm
(23-5/8")
CD-ROM
Manual and Other
Printed Materials
Rear Cover
Language Label
Sheet
1
Open the top cover and remove the
fixing tape.
2
Take the toner container from the bag.
6
Push on the PUSH marks on the toner
container until the container clicks into
place.
10
Insert the new waste toner box as
shown in the figure. When the box is
set correctly, it will snap into place.

Installation Guide

Environment
• Temperature: 10 to 32.5 °C (50 to 90.5 °F)
• Humidity: 15 to 80 %RH
• Power Supply: 120 V AC, 60 Hz, 7.7 A / 220 to 240 V AC, 50/60 Hz, 4.3 A
CAUTION: Be sure to provide enough space around printer. Prolonged use
without sufficient clearance may cause overheating.
Important:
Do not install the printer where temperature or humidity is outside the
recommended range. Print quality may suffer and there will be an increased chance of paper
jams.
Important:
When carrying the printer,
always hold the right and left sides as shown.
2
Insert the protrusion at the left of the rear cover into the hole in the printer. The rear
cover is fixed.
3
Shake the new toner container at least
10 times as shown in the figure in order
to distribute the toner evenly inside the
container.
7
Close the top cover.
11
Close the left cover.
Attaching the Label
Attach the included language label
sheet on the indicator as shown in the
figure.
4
Remove the label from the toner
container.
8
Open the cap of the waste toner box.