Testing The Electronics - Carrier KN-COPP-3-RC User Manual

Operation

Testing the Electronics

You should test the alarm once a week,
below. If at any time you test the alarm and it does not perform as
described below, have it replaced immediately. See "How to know if your
alarm is malfunctioning" on page 17 for a description of the characteris-
tics of a malfunctioning alarm and what you should do if a malfunction
occurs.
Observe the alarm weekly to make sure the red dot is blink-
ing, indicating normal operation.
If the dot is not blinking, unplug the alarm, then plug it in
again. This will clear the alarm for restart. If the dot does
not resume blinking, your alarm may be malfunctioning.
To test the alarm, press the Test/Reset button. If the unit is operating
properly, you should notice the following:
• The display shows three eights
ber (usually around 200). You will then hear 4 quick beeps
– followed by 5 seconds of silence – followed by 4 quick beeps.
The unit will then show the three eights for several seconds. It
will then return to monitoring for carbon monoxide.
Familiarize yourself and household members with the alarm pattern
described above. In the event of a CO incident, this pattern will continue
to repeat as long as CO is present.
NOTE: Pressing the Test/Reset button tests the functions of the alarm's
internal components, circuitry and micro-computer. YOU DO NOT NEED
TO PRESS THE TEST BUTTON TO TAKE A CO READING. CO read-
ings are automatically shown on the alarm's digital display. If the alarm
shows zero (0), then no measurable amount of CO has been sensed by
the alarm within the past 15 seconds.
16
following the directions listed
, and then shows a num-
Blinking Dot