Washer Fluid - Cadillac 2015 SRX Owner's Manual

10-18 Vehicle Care
A fluid loss in this system could
indicate a problem. Have the
system inspected and repaired.
How to Check Power Steering
Fluid
To check the power steering fluid:
1. Turn the engine off and let the
engine compartment cool down.
2. Remove the engine cover,
if required. See Engine Cover on
page 10-6.
3. Wipe the cap and the top of the
reservoir clean.
4. Unscrew the cap and wipe the
dipstick with a clean rag.
5. Replace the cap and completely
tighten it.
6. Remove the cap again and look
at the fluid level on the dipstick.
The level should be within the HOT
mark. If necessary, add only enough
fluid to bring the level within
the mark.
What to Use
Caution
Use of the incorrect fluid may
damage the vehicle and the
damage may not be covered by
the vehicle warranty. Always use
the correct fluid listed in
Recommended Fluids and
Lubricants on page 11-5.
To determine what kind of fluid to
use, see Recommended Fluids and
Lubricants on page 11-5. Always
use the proper fluid.

Washer Fluid

What to Use
When windscreen washer fluid is
needed, be sure to read the
manufacturer's instructions before
use. If operating the vehicle in an
area where the temperature may fall
below freezing, use a fluid that has
sufficient protection against
freezing.
Adding Washer Fluid
The WASHER FLUID LOW ADD
FLUID message appears on the
Driver Information Centre (DIC)
when the fluid level is low. See
Washer Fluid Messages on
page 5-39.
Open the cap with the washer
symbol on it. Add washer fluid up to
the fill mark. See Engine
Compartment Overview on
page 10-5 for reservoir location.