Summary of Contents for Site SMA400
- Page 1 INSTRUCTION MANUAL Jig Saw SMA400 008472 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
-
Page 2: Specifications
These values have been obtained according to EN60745. DOUBLE INSULATION ENH501-1 Declaration of Conformity Only for EU countries Site UK Ltd Do not dispose of electric equipment BA 22 8RT together with household waste material! In observance of European Directive 2002/96/EC on waste electric and... -
Page 3: General Power Tool Safety Warnings
GEA005-1 personal injury. Use personal protective equipment. Always General Power Tool Safety wear eye protection. Protective equipment such Warnings as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions WARNING Read all safety warnings and all will reduce personal injuries. -
Page 4: Specific Safety Rules
22. Keep cutting tools sharp and clean. Properly immediately after operation; they may be maintained cutting tools with sharp cutting edges extremely hot and could burn your skin. are less likely to bind and are easier to control. 13. Do operate tool no-load... - Page 5 the direction of number 5; lower speed is obtained when Applications Position Cutting action it is turned in the direction of number 1. Refer to the table to select the proper speed for the For cutting mild steel, stainless steel and plastics. workpiece to be cut.
-
Page 6: Operation
immediately after operation; they Hex wrench storage extremely hot and could burn your skin. 1. Base Tighten the saw blade securely. Failure to do so • 2. Hex wrench may cause a serious injury. When you remove the saw blade, be careful not to •... -
Page 7: Metal Cutting
001918 Loosen the bolt on the back of the base with the hex wrench. Move the base so that the bolt is positioned in For internal cutouts without a lead-in cut from an centre of the bevel slot in the base. edge, pre-drill a starting hole 12 mm or more in 1. -
Page 8: Dust Extraction
Dust extraction Use the cover plate when cutting decorative veneers, 1. Dust nozzle plastics, etc. It protects sensitive or delicate surfaces 2. Base from damage. Fit it on the back of the tool base. Anti-splintering device 1. Base 2. Anti-splintering device 001921 001929... - Page 9 Please retain this handbook in case you need to refer to any of the information in the future GUARANTEE This SITE product carries a guarantee of 12 months. If your product develops a fault within this period, you should, in the first instance contact your retailer.
- Page 12 Site (UK) Ltd 884711-229...
Need help?
Do you have a question about the SMA400 and is the answer not in the manual?
Questions and answers