HealthTrainer Health Trainer CLASSIC Treadmill HT-CLASSIC Owner's Manual page 7

Assembly
Step 3:
Connect the console harness from inside
the left upright to the console harness from
the base assembly as shown in Figure 3.
Next, attach left upright and right upright
to base using Allen bolts M8x15 (Qty. 8)
and washers 9x22x2 mm (Qty. 8). Do not
tighten bolts all the way at this time.
Step 4:
Attach the console assembly by connect-
ing the console harness, incline harness,
EKG harness, and speed harness as shown
in Figure 4.
Next, attach the console assembly to the
left and right uprights using Phillips screws
M6x12 (Qty. 4).
Figure 3
CONSOLE HARNESS
Figure 4
PHILLIPS SCREW
7
ALLEN BOLT
WASHER
CONSOLE
WIRE HARNESS
UPRIGHTS