MULTIFUNCTION LED LIGHT 3 AAA Cell Size Batteries Model CL1110
READ AND FOLLOW ALL INSTRUCTIONS BEFORE USING THIS PRODUCT
• Adult use only. This product is not a toy, keep away from children.
• Do not stare directly at the light emitted by this product.
• This product is resistant to rain and splashing water, but it is not submersible. Do not drop into or
immerse in water.
General Information
• This product operates on three (3) AAA size batteries (not included). LED light wattage: 1 W.
• For maximum power use alkaline batteries. Remove batteries from equipment which is not to be used for an extended
period of time.
• Do not mix old and new batteries. Do not mix alkaline, standard (Carbon - Zinc), or rechargeable (Nickel - Cadmium)
batteries.
• Remove used batteries promptly.
• Always purchase the correct size and grade of battery most suitable for the intended use.
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the device prior to battery installation.
• Ensure batteries are installed correctly with regard to polarity (+ and -).
• The LED is a lifetime light source. It will never need to be replaced.
• The operating time for this product depends on whether it is run continuously or intermittently. Intermittent use extends the
operating time of a set of batteries.
• Two additional battery housings are provided to hold two sets of three (3) AAA size batteries.
• To clean the product, use only a damp cloth. Avoid strong cleaner, excessive water and abrasive brush.
Functions and Operation
• ON/OFF push button: Sets light brightness in lantern and flashlight mode (see Fig 1 A):
Fig 1 A
• Function-switch: Selects operating mode via 3-way switch (see Fig. 2B):
INTEX
OWNER'S MANUAL
®
WARNING
SAVE THESE INSTRUCTIONS
Fig 2 B
SAVE THESE INSTRUCTIONS
(169IO) 5-IN-1 LED LIGHT ENGLISH 4.875" X 7.25" 11/18/2011
Page 1
(169IO) 5-IN-1 LED LIGHT ENGLISH 4.875" X 7.25" 11/18/2011
Press Button
Brightness
Once
Low
Twice
Medium
Three times
High
Four times
Off
* Based on 3 AAA fresh alkaline batteries.
Switch
Function/Operating Mode
Position
SOS
Emergency beacon – international SOS signal light
o
Lantern/Flashlight mode/OFF
HAZARD
Note: The 3-way switch functions take priority over the
ON/OFF push button functions. The brightness of the
flashing hazard light and emergency beacon light are
defaulted to full power (100%) and cannot be adjusted.
Page 2
169-*IO-R1-1211
Percent
Battery Life
8%
* 28 hours
50%
* 3 hours
100%
* 1 hours
Flashing hazard light
169
IO
169
IO
Need help?
Do you have a question about the CL1110 and is the answer not in the manual?
Questions and answers