Advertisement
Connect
EN
1
2
Press the red
on the right corner of the speaker.
Wait for light to become flashing white (this takes
30-90 sec.).
Next: Connect your PLAYLINK or PLAYCONNECT
to your home network via:
- An Ethernet cable (step 3); or
- WPS (step 4); or
- WiFi (step 5)
3
Ethernet Cable: See picture I.
Note: Ethernet connection not available on Playlink-4.
4
WPS: Press the Quick Connect key at the
back of speaker (with a toothpick or pen) and
WPS button of your router simultaneously
(picture II). Wait for the speaker LED to
become permanently white.
P.1
PL6 / PLAYCONNECT
AC
Ethernet Switch
RESET
LAN
USB
INTERNET
RJ45
Internet
Picture I
R
ST
L
MODE
QUICK
RESET
AUX IN
ETHERNET
AC IN 100-240V
CONNECT
DIR.MODE
50/60HZ 2.5A
RESET
LAN
USB
INTERNET
QUICK
RESET
AC IN 100-240V
R
ST
L
MODE
AUX IN
ETHERNET
CONNECT
DIR.MODE
50/60HZ 2.5A
Picture II
WiFi:
1.
Open the WiFi settings (via settings) on your device and connect it to the PLAYLINK network.
2.
Open your browser, you will automatically be
redirected to the login page. If not automatically
redirected, type in your browser the address:
172.19.42.1. Input a friendly name for your
speaker (picture III). Press next.
Note: This WiFi connection only works with
factory default or after a reset (please check
chapter 7.2 in the instruction manual).
3.
Select your network name and input the password
of your network. Press connect (picture IV).
4.
If successfully connected, you will see picture V
on the right and the LED becomes permanently
white.
If not: Make sure you are connected to the same
network as the speaker (check your WiFi settings).
If this does not work, please check Chapter 7.2 in
the Instruction Manual to reset your speaker and
start the procedure again.
Repeat from step 2 in order to connect other speakers on the network as well. If you use two PlayLinks in
a Stereo mode, please affect one set to 'Right' and the other to 'Left' via the R/ST/L button at the rear of
the speaker.
5
Picture III
Picture IV
Picture V
6
P.2
Advertisement
