Using Your New Tv; Getting Started; Step 1: Connect The Antenna; Connecting A Vcr - Sony Trinitron KV-XA29 Operating Instructions Manual

Using Your New TV

Getting Started

Step 1
Connect the antenna
If you wish to connect a VCR, see the Connecting a VCR diagram below.
or
Antenna cable (not supplied)
Antenna cable (not supplied)

Connecting a VCR

To watch the video input, press VIDEO (see page 12).
To antenna
output
VIDEO IN
VIDEO OUT
To video and
audio outputs
4
Using Your New TV
CAUTION
• Do not plug in the power cord until you have completed making all other
connections; otherwise a minimum leakage current might flow through
the antenna and other terminals to ground.
• To avoid battery leakage and damage to the remote, remove the batteries
from the remote if you are not going to use it for several days. If any
liquid that leaks from the batteries touches you, immediately wash it
away with water.
F connector
(not supplied)
Antenna cable (not supplied)
VCR
AUDIO VIDEO
S video cable
R L (not supplied)
To
S video output
Audio/Video cable
(not supplied)
Tip
• With the "VIDEO MULTI SYSTEM" input terminal, you can also receive
PAL, NTSC and SECAM video signals when using the VIDEO IN 1, 2 or 3
jacks, or the VIDEO 3 INPUT jacks at the front of your TV.
Rear of TV
Rear of TV
To 8
(antenna)
To S VIDEO
input
VIDEO (yellow)
AUDIO-L (MONO) (white)
AUDIO-R (red)
: Signal flow
COMPONENT VIDEO(DVD) IN
R
L Y C C
B R
VIDEO
MONITOR
IN
OUT
1 2 3
VIDEO
S VIDEO
AUDIO
To VIDEO IN
1, 2, or 3
: Signal flow