Tamron 300QV-P-CM Installation Manual page 2

How to Mount
Mounting on the wall with a mount bracket
1. Place the template (printed on this document) and drill thread holes
When using a gypsum board anchor, etc., follow the precautions such
as a thread hole diameter.
Commercially available gypsum
board anchor
Sample of board anchor
2. Attach the mount bracket
Use 4 commercially available screws to secure the mount bracket.
Note:
• The screws of 4mm diameter must be long enough to mount the camera.
3. Attach the anti-falling wire to the camera
Mount the washer using the wire fixing
screw.
→ See "Owner's Manual - Installation"
Mounting on the ceiling with a mount bracket
When installing the camera onto the ceiling and the ceiling material is
a gypsum board, etc. which does not have enough strength, provide
sufficient reinforcement or make sure to use a commercially available
gypsum board anchor, etc. along with the mount bracket.
Drill holes for the mounting screws, mount the camera in the same man-
ner as shown above Step 1 to 5.
●
Make sure the anti-falling wire is inserted through the
hook of the mount bracket.
Tamron co., Ltd. Industrial Optics Business Unit
1385, Hasunuma, Minuma-ku, Saitama-shi, Saitama 337-8556 JAPAN
Tel: +81-48-684-9129 Fax: +81-48-683-8594 E-mail tokki@tamron.co.jp
4. Insert the anti-falling wire to the hook of the mount bracket
(See 1, 2 and 3 below)
Hook the wire from the bottom notch 1, rotate it 2 and make it look as shown
in 3.
5. Mount the camera to the mount bracket and secure it with the 2
camera unit mounting screws (supplied with the mount bracket)
1
2
3
Anti-falling wire
Anti-falling wire
Mounting directly on the ceiling
(Same for mounting directly on the wall)
1. Place the template (printed on the Owner's Manual - Installation)
and drill thread holes
→ See "Owner's Manual - Installation"
2. Mount a hook screw, etc. on ceiling beams or structural materials
and hook the anti-falling wire to it.
3. Use 2 commercially available screws to mount the camera
Note:
• The screws of 4mm diameter must be long enough to mount the camera.
●
This procedure should be done only when the mounting screws can
reach the ceiling beams or structural materials and sufficient mounting
strength is ensured.
Insert the camera cables between the
groove of the camera unit and the U
shaped notch of the mount bracket
and make sure there no cables are
wedged.
Note:
• The notch must be placed
so that it comes to the up-
per side of camera image.
Lens protective cover
Camera unit mounting screws
456-00
Printed in China