Master Power - Philips AH673/44 Owner's Manual

and installing the cable as shown in the illustration. It may also be connected
to the tuner by first installing an F type screw on connector on the end of the
cable and then attach the cable to the 75 ohm connector of the tuner as
shown in the connection diagram.
Id
300 OHM
FM ANTENNA
TWIN LEAD
75 OHM
COAXIAL
CABLE
When you install an outdoor antenna, it should be oriented to provide maximum
signal strength and minimum reflections. The antenna should be as far away
from roads and streets as possible since passing cars and trucks can cause
reflections. By using the signal strength and multipath meters, the correct
antenna position is indicated by maximum deflection of the signal strength
meter and minimum deflection of the multipath meter.
AM ANTENNA
The bar antenna mounted on the back of the tuner will provide satisfactory
reception of local stations. The 3dimensional mounting allows you to position
the antenna to eliminate interference and increase the signal strength.
-
,
: >
AM BAR ANTENNA
I I
If you live in an area where satisfactory reception cannot be obtained by
using the bar antenna, an outdoor AM antenna should be connected to the
AM terminal of the tun
r.
NOTE: All wires and cables should be
routed away from the
1
M
antenna since it is possible for these
wires to introduce feedback into the tuner through the antenna.
CONTROLS
-
MASTER POWER
The Master Power switch, located on the back panel of the tuner, controls the
power for all of the circuits except the unswitched AC receptable.'This switch
must be in the On position for the tuner to operate. If the tuner will not be
used for an extended period of time, such as when you are on vacation, place
the Master Power switch in the Off position.