Edge DiskGo! Operation Manual page 3

c. Specify the location where you saved the driver file (from Step 2 above) and click "Next".
d. Click the "Next" button to install the driver.
e. After installing the driver, click the "Finish" button to complete the driver installation. (Note: after this
step,
the "Add New Hardware Wizard" may reappear. This is normal. Repeat the above steps to completely
install the driver)
f. Restart the computer.
Format Using the Windows Format Function
1) Ensure the USB Disk switch is set to USB.
2) Connect your DiskGO!
open "My Computer".
3) Right-click on the Removable Disk icon for the drive letter corresponding to your device and select
"Format".
4) Select the file system to use.
PCs and Macs, use the FAT or FAT32 file system.
5) If you do not wish to delete the data, or need to back up the data to another device (like your hard drive),
select "Cancel"; otherwise select "OK" to proceed.
format process.
6) Click "OK" to return to Windows.
Format Using MacOS
1) The USB Disk switch can be set to ON or OFF for flash drive usage (Note: switch must be set to ON for
battery to charge).
2) Connect your DiskGO!
3) Once the device appears on your desktop (usually titled "No_Name"), open your computer's main hard
drive – the one with your active system folder.
4) Open the Applications folder, then open the Utilities folder.
5) Double-click on the "Disk Utilities" icon to launch the program.
6) In the left pane, single-click to select the device named "XXXMB Removable Disk".
7) Click on the "Erase" tab.
a. If you are using your DiskGO!
computers, select "MS-DOS".
b. Enter a label for your DiskGO! here, if necessary.
8) Once you have selected the options you wish to use, click the "Erase" button.
complete, you can close the Disk Utility and begin using your USB Flash Drive.
Removing the DiskGO! Safely
Please follow the directions below to safely remove your device.
· Windows 98SE:
and writing data.
· Windows ME/2000/XP:
DiskGO! device.
· MacOS: Drag the "Removable Disk" icon to the Trash Bin and wait for indication that you can safely
remove the device.
· Linux: You can safely remove the DiskGO!
command.
REC (MIC recording & playback) Mode:
The DiskGO!
TM
jack. The device uses the microphone to save voice recordings to the internal disk as WAV files.
recordings can be played back through the device itself, or copied to your computer for playback.
MIC Recording
1) Switch the device to ON (Green LED will light up for several seconds, then go off).
2) Switch the MP3/REC switch to REC. Press Pause/Play button for 2 seconnds and release. A solid yellow LED
will appear.
3) Press Play/Pause quickly again to begin recording.
4) Press and release Play/Pause to stop recording.
WAV playback
1) Switch the device to ON (Green LED will light up for several seconds, then go off).
2) Switch the MP3/REC switch to REC. Press Pause/Play button for 2 seconnds and release. A solid yellow LED
will appear.
3) Press and release Play/Pause to begin playback.
PLEASE CONTACT A QUALIFIED TECHNICIAN FOR ASSISTANCE IN INSTALLING THIS PRODUCT IF YOU ARE NOT
FAMILIAR WITH DOING SO. ANY INSTRUCTIONS INCLUDED WITH THE PRODUCT ARE FOR CONVENIENCE ONLY
EDGE is a trademark of EDGE Tech Corp. Trademarked words or logos used herein are property of their respective owners.
TM
MP3 Player + USB Flash Drive to the computer using an available USB port, then
TM
If you anticipate using your DiskGO!
When the format is complete, you will see the following message: "Format Complete!".
MP3 Player + USB Flash Drive to your computer's USB port.
TM
Select the appropriate option for your system.
TM
Unplug ONLY when the device is in standby mode.
Use the "Unplug or Eject Hardware" icon in the system tray to safely stop the
MP3 Player + USB Flash Drive device contains a built-in microphone near the headphone
AND ARE NOT INTENDED TO BE ALL-INCLUSIVE.
327 East 14th Street / Ada OK 74820 (800) 332-6581 / (580) 332-6581 / www.edgetechcorp.com
The progress bar indicator displays the status of the
MP3 Player + USB Flash Drive on both Macintosh and PC
MP3 Player + USB Flash Drive after you use the "Unmount"
TM
Recording begins when the LED blinks red and yellow.
The LED will return to solid yellow.
The LED will blink yellow and red during playback.
IMPORTANT
MP3 Player + USB Flash Drive on both
TM
Once the Disk Utility is
The LED Indicator blinks while reading
These