Table of Contents
Advertisement
N6DHP(L, M, H, LR, MR)
Peg Bar Information for Cannon
Magna Peg Bar Display Systems
(TYLER supplied)
Air baffle shelves should always be used
with peg bars for hanging meat displays.
Air baffle shelves are non-load bearing and
are used only to help direct the air flow. The
air baffles should be installed above each row
of peg bars, except the top row, along with a
bottom shelf. Air baffles are available from
TYLER that are compatible with 15" offset
support arms.
1. 48" peg bar with 52 holes to accept pegs.
Flat side of holes in peg bar must be down
and to the front of the bar. Attach two hook
brackets to peg bar with two clamp brackets
and four screws. Position and install peg bar
in slotted holes in back of case.
2. 15" pegs and offset support arms lock in
place on the peg bar.
After marking the desired locations in the peg
bar, install the pegs into peg bar holes. Hold
peg at 90° angle to peg bar. Insert peg into
hole in peg bar. Rotate peg until angled end
Page 16
Tyler Refrigeration
points up. Pull peg out until peg sits properly
in the peg bar.
Offset support arms must be installed in the
peg bar so the notches in the air baffle can fit
over them. Install support arms in the same
manner as the pegs (with offset up).
3. Non-load bearing air baffle should run the
same width as the peg bar. Air baffle
rests on the two offset support arms. The
notches in the air baffle must fit over the
support arms. NOTE: The air baffle
should be solid in design and posi-
tioned 1" in front of the rear duct and
5.5" back from the rear edge of the
card moulding.
4. Card moulding is offset 2" in front and
3/4" above the pegs.
Slide the card moulding onto the two offset
support arms. Center the card moulding so it
is aligned with the peg bar. Secure the card
moulding on the offset support arms with two
spring clips. To remove card moulding,
squeeze each spring clip together until the
card moulding releases.
August, 2005
Hide quick links:
Advertisement
Table of Contents
