Connecting To The Mains Supply - Linn KLIMAX DS Installation And Setup Manual

KLIMAX DS SYSTEM
INSTALLATION AND SETUP
6 KLIMAX DS INSTALLATION (continued...)

Connecting to the mains supply

The Klimax DS contains an automatic internal mains voltage
switch. This switch operates on all worldwide mains voltages from
100 V to 240 V. The unit can be connected to any worldwide mains
voltage with no adjustment.
This unit must be earthed. Use the earthed moulded mains lead
supplied, or if no mains earth is available, ensure the product's
EARTH GROUND connector is connected to an earthing terminal.
RS232 connection on Klimax Kontrol and CD12
For communication to take place between the components in a Klimax
DS system, the RS232 connection must be enabled on the Klimax Kontrol
and CD12.
Klimax Kontrol
The RS232 Connection user option must be set to 'Enabled'. This is the
default setting, so unless it has been changed no alteration is required.
If the setting has been changed, or you wish to check it, follow the
instructions below.
1. Put the Klimax Kontrol into standby.
2. Hold STANDBY on the front panel until the front panel display shows
'SLEEP DISPLAY'.
3. Repeatedly press SOURCE – until the display shows 'RS232
CONNECTION'.
4. To change the setting, press VOLUME +.
5. Press STANDBY.
CD12
To enable the RS232 connection on the CD12 requires an internal
change to the unit. This procedure is detailed in the CD12 Software
Pack Version 1.3 document, which can be found within the following
software pack CD12 boot-PROM Upgrade Procedure Rev.
Linfo's Sondek CD12 product information page.
2 3
2, on
w ww. l i n n. co . uk