Sanding Operation - Makita BO6030 Instruction Manual

Emptying dust bag
1
003735
When the dust bag is about half full, switch off and
unplug the tool. Hold the tool and remove the dust bag
from the dust nozzle while pressing the push button.
1
2
3
003736
After emptying the dust bag, insert the hook on the dust
nozzle into the rectangular hole on one side of the dust
bag frame and push up the dust bag frame until it clicks
into place on the push button.
003737
Installing paper dust bag (optional accessory)
Place the paper dust bag on the paper dust bag holder
with its front side upward. Insert the front fixing cardboard
of the paper dust bag into the groove of the paper dust
bag holder.
2
1
3
003742
1. Dust nozzle
2. Push button
2
1. Hook
2. Dust nozzle
3. Dust bag
4
4. Push button
1. Groove
2. Front fixing
cardboard
3. Front side of
paper dust bag
Then press the upper part of the front fixing cardboard in
arrow direction to hook it onto the claws.
1
003743
Insert the notch of the paper dust bag into the guide of
the paper dust bag holder. Then install the paper dust
bag holder set on the tool.
1
003744
003745
OPERATION

Sanding operation

003746
CAUTION:
Never switch on the tool when it is in contact with
•
the workpiece, it may cause an injury to operator.
Never run the tool without the abrasive disc. You
•
may seriously damage the pad.
6
1. Claws
2. Upper part
2
1. Notch
2. Guide
2