Invacare Action 4 User Manual page 24

- Comfort seat (photo 18)
It is removable allowing the folding of the wheelchair ;
simply lift the cushion and put it away, then grab the two seat
holding tubes and pull them upwards.
Repeat the operation in reverse order to unfold the wheel-
chair (see paragraph 2.1.1).
i
The padding and outer cover of this seat will wear; please
contact your dealer for possible replacement.
Make sure the cushion is properly positioned on the 3 seat
Velcro fasteners to provide safety and comfort for the user.
Keep your fingers away from movable parts to prevent injuries
during folding and unfolding !
22
- Comfort backrest (photos 19 & 19A)
It is made up of a rigid shell (A) and a preformed foam
cushion (B) which is locked in place by Velcro fasteners thus
providing optimal comfort.The backrest is removable to allow
the folding of the wheelchair; loosen both buttons (C), slide
the levers (D) to the inside and disengage the hooks (E) from
their supports. Reverse the procedure to reassemble the
backrest.
A
B
D
19A
19
!
It is recommended that this operation be performed
only by the attendant.Always make sure that the backrest is
locked in place for optimal safety of the user.
Make sure the backrest cushion Velcro fasteners are in good
state and well positioned. Keep your fingers away from mova-
ble parts to prevent injuries.
Note : for maintenance of your DARTEX
soft rag soaked with alcohol.
- Comfort headrest (photo 20)
It is removable, completely loosen the ball screw (A). It is
height adjustable, slightly loosen the ball screw (A), adjust to
the desired height, tighten without forcing.
The cushion also is angle, depth and height adjustable by ope-
rating simultaneously the lever (B) and screws (C).
Note : make sure that the indexable lever is properly
oriented to prevent any bother or injury to the user or
attendant.
!
Do not adjust the head rest when the user leans on it
and check the mounting to the backrest in order to prevent
injuries.
C
B
A
C
E
20
®
cover, only use a