Download Print this page

Klutch 375354 Owner's Manual

4 1/2in. angle grinder stand

Download this manual

Enlarged version

WARNING

Some dust created by power sanding, sawing, grinding, drilling, andother

construction activities contains chemicals known to the State of California to

cause cancer, birth defects or other reproductive harm. Some examples of

these chemicals are:

• lead from lead-based paints,

• crystalline silica from bricks and cement and other masonry products, and

• arsenic and chromium from chemically-treated lumber.

Your risk from these exposures varies, depending on how often you do this

type of work. To reduce your exposure to these chemicals: work in a well

ventilated area, and work with approved safety equipment, such as those dust

masks that are specially designed to filter out microscopic particles.

Distributed by

Northern Tool & Equipment Co., Inc.

Burnsville, MN 55306

NorthernTool.com

MadeinChina

4 1/2in. ANGLE

GRINDER STAND

OWNER'S MANUAL

Item # 375354

Item # 143371

0311

Page 1 OWNER'S MANUAL masks that are specially designed to filter out microscopic particles. Distributed by Northern Tool & Equipment Co., Inc. Burnsville, MN 55306 NorthernTool.com Item # 375354 Item # 143371 MadeinChina 0311...
Page 2: Intended Use
Thank you very much for choosing a KLUTCH product! For future reference, please complete the owner's record below: Model: _______________ Purchase Date: _______________ Save the receipt, warranty and these instructions. It is important that you read the entire manual to become familiar with this product before you begin using it.
Page 3 Assembly: 5. The 2 x M10x30mm Bolt with nut, 2 x M8x25mm Bolt with nut, 2 x M6x25mm Bolt with nut and 4x plastic spacer included in the pack are for assembling different 1. Unscrew the two bolts on the jaw clamps and use these two bolts to fix the sizes of angle grinders on the stand.
Page 4 7. Use hex key (not included) to fully tighten the two bolts on the jaw clamps 10. Adjust bolt (B) and bolt (C) again to make sure that the disc can still locate in (See Figure 9). the middle of the cutting slot on the base. 11.
Page 5: Parts Diagram
16. Reassemble the bolt (D) on the stand and fully tighten it by using an Part# Description Specifications Quantity adjustable wrench (not included) (See Figure 17). Base Bracket Hex screw M8×14 Spindle 10×59 Flange Stand Spring Washer ¢14×¢6.3×1.5 Hex screw M6×16 Clip Hex nut...