Table of Contents
Advertisement
Quick Links
V6.3
Smart Entry
TM
Model 20083 / 25583
Model 20084 / 25584
Installation Manual
7955 Cameron Brown Court
Springfield, Virginia 22153 USA
Tel: 703-866-2000 ; Fax: 703-866-2001
Congratulations on your purchase of the Smart Entry
tm
Smart Entry
Protects You:
Lock and unlock your doors & trunk by remote control.
Optional Features Include (external relays necessary):
Car Locator
Remote Panic/Rescue alarm
Turn on your domelight by remote control.
Starter-kill to prevent vehicle from being stolen.
Additional alarm input for other sensors.
Passive or active operation (also locks doors).
This system allows for a very quick installation using the generic harness (part
#27004) or with 'plug-in' vehicle specific harnesses. The transmitter which comes
with the unit is already programmed to the receiver and includes a long life lithium
battery that will last many years.
CONTENTS:
tm
Smart Entry
Module
Transmitters (3 button)
Parts Baggie
Type of Lock and Unlock Outputs
Contained in the baggie:
4 cable ties
2 "Protected by DesignTech" window stickers
Tools Required:
Set of screw drivers
Wire cutter and strippers
Soldering iron and solder
tm
Smart Entry
model 20084 has 2 built-in relays to control Lock and Unlock.
All other outputs are negative transistor outputs (-400mA) and require external
relays.
Page 2
tm
from DesignTech.
Model
20083
20084
25583
25584
YES
YES
1
1
Yes
Yes
Transistor
Relay
Drill and 1/2" drill bit for switch hole
Crimping tool
Test / Volt meter
20083 / 20084
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for DesignTech Smart Entry 20083 / 25583
Summary of Contents for DesignTech Smart Entry 20083 / 25583
-
Page 1: Installation Manual
Type of Lock and Unlock Outputs Transistor Relay Contained in the baggie: 4 cable ties 2 "Protected by DesignTech" window stickers Tools Required: Set of screw drivers Drill and 1/2" drill bit for switch hole Wire cutter and strippers Crimping tool... - Page 2 RED/BLACK This is the On/Off Control switch wire. This switch will al- Mounting and Connecting the module: ready be connected to the harness. You will notice that one side of the switch goes to the Red/Black wire and the other The information that follows shows the generic wire harness list.
- Page 3 For the following Lock/Unlock wires -- see the separate GREEN SHEET 13. TRYING OUT THE UNIT: for vehicle wiring colors and locations as well as for instructions for Always keep one window rolled down to avoid locking yourself out of the vehicle. hook-up.
- Page 4 14. PROGRAMMING OPTIONS: 15. PROGRAMMING METHOD: There are 4 options which can be set as described in the Programming Method section This section will set or reset any of the four options. following this section. Turn the Control Switch (the toggle switch) OFF (down). (The switch has a A.
- Page 5 Toggle the valet switch four times off and on and the alarm will disarm. shows a Bosch 30 Amp relay being used. For any technical assistance regarding this product you may call DesignTech on our toll-free telephone number - (800) 337-4468.
- Page 6 Smart Entry B. Garage Door Receiver Unit will allow Your transmitter to operate an ranty period, and if the product is defective DesignTech International, Inc. will at its option repair or replace such. electric garage unit. C. You can remotely control your vehicle with our AutoCommand model 20022.
Need help?
Do you have a question about the Smart Entry 20083 / 25583 and is the answer not in the manual?
Questions and answers