Dynex DX-922 Quick Setup Manual

DX-922 / DX-1022 / DX-1122 / DX-1222
Mobile Battery Pack
Before using your new product,
please read these instructions to prevent any damage.
QUICK SETUP GUIDE

Package Contents

• Mobile Battery Pack
• Micro USB Charging Cable
• Quick Setup Guide
Charging the mobile battery
Fully charge your mobile battery pack
before using it for the first time.
LEDs
OUT 5V/1A
Micro
IN 5V/1A
USB
(input)
1 Plug the small end of the USB cable
into the mobile battery's microUSB
port (input).
2 Plug the large end of the included
USB cable into a standard USB port on
your computer, car charger, or wall
charger (not included). The mobile
battery automatically begins
charging.
Charging your electronic
device
USB (output)
OUT 5V/1A
IN 5V/1A
1 Plug the large end of the USB cable
into the mobile battery's USB port
(output).
2 Plug the small end of USB cable into
your device.
The mobile battery automatically
begins charging your device.
Recharge the mobile battery when the
LED starts blinking.
Note: If your device requires a different
connector than the one provided, use
the cable that came with your device