WiDrive DX-225 Quick Start Manual

Portable Application Storage Server
4

AP Mode Connecting

Set the Network Type
Selection switch as the arrow
direction [Access Point]
Then press Power ON/OFF
button
Infrastructure Access Point
On WinXP computer,
unplug any wired network
connection, if present.
Next, click on [Start] and
right-click on [My
NetworkPlace].Select
[Properties].
Right-click on Wireless
Network Connection and
Select [View Available
Wireless Networks].
Wait 5 to 15 Seconds for list
of wireless networks to be
refreshed.
Select [WiDRIVE ]
wireless computer
-to-computer network.
Click [Connect].
For Window Vista Computer, left click on
left bottom corner of the computer screen) and select
Connect or Disconnect ...
On the Connect to Network pop-up Screen, then double click
on [WiDRIVE ] wireless computer-to-computer network to
connect.
Support@edslab.com
Quick Start Guide
DX-225
Portable Application Storage Server
If user does not see list of wireless networks, consult the
wireless card's vendor or software for further instructions.
Next, launch
internet browser
and key in the
IP address
"192.168.2.1"
At the WiDRIVE
webfolder login
screen, select
the Username:
[Admin] and key
in the Password
"admin"
Click on [C]
drive.
User is ready to
upload, download
and change the
setting in Control
pannel in WiD-
RIVE.
5

Setup Wizard/Connection Utility

Please put the installation / Setup CD into the Computer.
i. WiDRIVE User's Manual (User Manual.pdf).
ii. WiDRIVE Setup Installer (WiDRIVE _setup.exe).
iii. WiDRIVE Utility (Utility Setup.exe)
Click on WiDRIVE_Setup.exe to start the WiDRIVE Wizard
and utility installation on WinXP or WinVista computer.
(located at
For more information or question, please kindly see the
User Manual. Free software drivers for all EDSLab Tech-
nologies products are available 24 hours per dat at the
www.edslab.com. or Please contact us
Support@edslab.com
DX-225
Portable Application Storage Server
DX-225
Quick Start Guide
EDSLab Technologies Inc.
Quick Start Guide