Page 2
Thank you for choosing this Goldair Food Processor. This Goldair appliance has been designed and manufactured to the highest of standards and with proper use and care, as described in this leaflet, it will give you years of useful service. Please read these instructions carefully.
Components BEFORE FIRST USE • Before using the food processor, wash all parts except the Base in hot, soapy water, rinse dry. These parts also be placed in the dishwasher on the top race. Do not put in or near the utensil basket. •...
Page 4
• ASSEMBLY • Make sure the control knob is in the OFF position and the power cord is unplugged • Be sure food processor base is on a flat, dry, clean, stable surface before you begin processing • To assemble, put the bowl on the base by placing the bowl handle at the 5 o’clock position on the base(see Fig.2).
Page 5
• CHOPPING • Lock he bowl onto the base as described in assembly • Place the chopping blade onto the center post (see Fig.4) • CAUTION: Blades are sharp, handle carefully. • Place food to be chopped into bowl, refer to food guide to prepare food for chopping •...
Page 6
• WARNING: Slicing/Shredding Disc is very sharp. Use caution when handing • Lock the bowl cover onto the bowl, remove the food pusher and leave in the open position. • Fill the food chute with pieces of food such as potato, cabbage, green pepper, tomato, etc.
CHOPPING GUIDE FOOD AMOUNT DIRECTIONS BABY FOOD Up to 2 cups(500ml) Add up to 2 cups(500ml) cooked vegetables and/or meat to bowl, along with 1/8 cup(30ml) liquid per cup of solid food. Process continuously to desired fineness. CRANBEARIES, MINCED 2 cups(500ml) Pulse to chop to desired fineness.
SLICING GUIDE FOOD DIRECTIONS APPLE Halve and stack horizontally in chute. Use firm pressure. CABBAGE/LETTUCE Halve head, Cut to fit chute CARROTS Cut to fit chute CELERY Remove string. Pack chute for best results. CUCUMBER Cut to fit chute MUSHROOMS Stack chute with mushrooms on their sides for lengthwise slices.
IMPORTANT: Never store any blade or disc on the motor shaft. No blade of disc should be placed on the shaft except when the processor is about to be used. SUPPORT AND TECHNICAL ADVICE North Shore City, Auckland, New Zealand Monday – Friday 8am-5pm Phone: 0800 232 633 Website: www.goldair.co.nz...
Page 10
Your Goldair product has been inspected and tested and is guaranteed subject to the following for a period to two years from the date of purchase against defects in workmanship and materials. During this period, such defects will be rectified by repair or replacement of the product purchased.
Need help?
Do you have a question about the FFP200 and is the answer not in the manual?
Questions and answers