Table of Contents
Advertisement
Table of Contents
Main Menu
5. Block the wheel that is
diagonally opposite the one to
be changed.
6. Loosen, but do not remove,
the wheel nuts by turning the
wrench counterclockwise.
7. There are two jacking points
on each side of the vehicle.
Set the jack in position, as
shown.
JACK
JACK BAR
JACK HANDLE
FRONT
The lift point is the outer bolt
head at the crossmember.
REAR
Under the rear axle
housing near the wheel.
Position the jack at the correct
jack point as shown.
Make sure that the jack is
positioned on a level and solid
surface.
Do not position the jack at any
points other than those specified.
In Case of Emergency
187
Advertisement
Chapters
Table of Contents
