Related Manuals for Kenyon Sirocco B81200 Series
Summary of Contents for Kenyon Sirocco B81200 Series
- Page 1 SIROCCO VENTILATION HOOD OWNER’S GUIDE READ AND SAVE THESE INSTRUCTIONS Models: B81200 Series...
-
Page 2: Important Safety Instructions
Important Safety Instructions Take care when using cleaning agents or detergents. Select products suitable for use in household cooking area only. Certain locales require make-up air calculations for total airflow. Consult your local codes and an HVAC professional before installing or using this hood. CAUTION - To reduce risk of fire and to properly exhaust air, be sure to duct air outside –... - Page 3 Cabinet Front View Fixing Point 1 Fixing Point 2 Cabinet Top View Internal Width Rearside of the Cabinet/Hood Cut-Out for 1/2" Conduit * Do not consider the door of the cabinet ** Use spacers for 1/4" wider cabinet Cabinet Right/Left Side View min Depth of Recessed Area =...
-
Page 4: Installation
Installation Figure 3 Cabinet Door Fixing point 1-2 Template cutout for 1/2" Conduit and 5" Duct Backside border Backside of Blind hole the cabinet (Side Springs Housing) Figure 4 Figure 5 Prepare the cabinet for installation • Mark and cut-out the cabinet bottom as shown in figure 3. •... -
Page 5: Install The Hood
Installation Figure 6 Cabinet Door Fixing point 1-2 Template cutout for 1/2" Conduit and 5" Duct Backside border Backside of Blind hole the cabinet (Side Springs Housing) Figure 7 Figure 8 Install the Hood • Set the motor housing into the opening. •... -
Page 6: Final Installation Steps
Figure 8 Box adjustment The hood can be installed in cabinets with different depths (see also figure 1 for details); however the front of the slider box must always be flush with the front of the cabinet. For alignment, adjust the back stops of the box. For box adjustment, loosen screws M, slide the square plates P as necessary, and tighten screws M (Figure 8). - Page 7 Use and Care Control Pad Functions Motor Housing Slider Left Grease Filter Handles Lamp Shield Figure 7 Operating Instructions The blower should be turned on for about 5 minutes before cooking in order to establish air currents upward through the hood. Use the low speeds for normal use and the higher speeds for strong odors or fumes.
-
Page 8: Hood Cleaning
Hood Cleaning Figure 8 Lights replacement Figure 9 Be sure lights are cool before cleaning the hood. To Clean Filters • The metal grease filters will last forever. They are made of anodized aluminum • It is recommended that the filters be washed at least once a month; they can be washed by hand or in the dishwasher. - Page 12 LI1QVB Ed. 05/02...
Need help?
Do you have a question about the Sirocco B81200 Series and is the answer not in the manual?
Questions and answers