Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Gira 1220 00
Summary of Contents for Gira 1220 00
- Page 1 Operating Instructions External Camera 1220 00...
-
Page 3: Table Of Contents
IR lighting and automatic white balance. The external camera can be installed anywhere in the entrance area and can be integrated into the Gira door communication system via the DCS-camera-gateway. The integrated temperature-dependent camera heating prevents condensation from forming on the camera cover due to changing climactic conditions and thus provides a clear view. -
Page 4: Installation
Installation ESD warning Important: Electrostatic charging! Before opening the housing and working on cabling please discharge by contacting with earthed metal parts to avoid damage to the device. Cable feed Cable feed can be either surface-mounted or flush-mounted. The accompa- nying cable gland with strain relief must be used to ensure IP 66 protection. -
Page 5: Mounting Base Plate
Mounting base plate 1. Position the accompanying hole template at the intended installation location and mark the drilling holes. 2. Drill the mounting holes and fasten the base plate with the accompanying screws and plugs. Inserting camera module 1. Position the camera module and base plate so that the 15-pole plug and 15-pole pin jack face each other. -
Page 6: Mounting Dome
Mounting dome Before mounting the dome, carry out connection and start-up of the camera. Mounting the dome: 1. Pay attention to proper seating of the seal when mounting the dome. 2. Fasten the dome to the base plate with 3 screws. 3. -
Page 7: Start-Up
Start-up During start-up, a monitor can be connected to the secondary video output for checking the camera image. Video output Aligning lens The camera lens can be adjusted in 3 axes. Module rotation (1st and 3rd axis) must not exceed 360°. Swivelling Tilting Rotating... -
Page 8: Setting Focus And Zoom
Setting focus and zoom The zoom factor and focus each have a setting screw on the underside of the lens. These screws also function as fixing screws for the lens. Setting zoom and focus: 1. Loosen the setting screws. 2. Carry out settings for zoom and focus according to requirements. -
Page 9: Setting Camera Parameters
Setting camera parameters The following setting options are available on the device PCB: Iris level potentiometer (1) For setting the basis aperture of the auto iris lens Slider switch for IR range (2) The range of the IR light can be set in 3 steps (HI: 20 metres;... -
Page 10: Technical Data
Technical data Power supply: 12 V DC Current consumption: max. 120 mA (IR off), max. 310 mA (IR on) Protection type: IP 66 Operating temperature: -20 °C to +50 °C Humidity: 0 to 85%, non-condensing Dimensions (HxØ): 99.5 x 145 mm Standard: TV lines: 550 TVL... -
Page 11: Warranty
Warranty We provide a warranty in accordance with the statutory requirements. Please send the device postage paid with error description via the specialist trade to our central customer service centre. Gira Giersiepen GmbH & Co. KG Service Center Dahlienstraße 12... - Page 12 Gira Giersiepen GmbH & Co. KG Electrical Installation Systems P.O. Box 1220 42461 Radevormwald Phone +49 (0) 2195 / 602 - 0 Fax +49 (0) 2195 / 602 - 339 www.gira.com info@gira.com...
Need help?
Do you have a question about the 1220 00 and is the answer not in the manual?
Questions and answers