INSTRUCTIONS q
Bluetooth
HEADSET
®
VS-3
Name and the Passkey
• Name:
ICOM-BT002
• Passkey: 0000 (four zeros)
The name is displayed on the paring list of other Bluetooth
devices when a Device Search is made.
Panel description
Earphone jack (3.5 (d) mm: 1 ⁄ 8 inch)
Microphone
Clip
[FWD]
[PTT]
[VOL](+)
[PLAY]
[VOL](–)
[RWD]
LED indicator
[RESET]
[PWR]
USB port for
charging
Before using the headset
Fully charge the headset before using, and when the LED
blinks every 3 seconds.
How to charge the VS-3
Make sure the headset power is OFF.
q
• If it's ON, hold down [PWR] for 3 seconds.
w
Open the USB port cover, and then connect the VS-3 to
a USB power adapter, or a PC, with the supplied USB
cable.
• The charging temperature range: 0ç to +45ç
(32ƒ to +113ƒ)
• While charging, the LED lights red.
• When the charge is completed, the LED turns OFF.
Power adapter
(third party)
VS-3
To a USB port
PC
Thank you for purchasing the VS-3
Bluetooth
.
set
This headset is compatible with Bluetooth
tion, and includes a [PTT] switch.
Please read these instructions carefully and com-
pletely before using.
Supplied accessories
• Earphone (SP-36)+Earpad
• USB cable for charging (OPC-2326)
• Instruction sheets q (this sheet) and w
®
Features
The VS-3
®
enables you to hands-free op-
Bluetooth
headset
eration with a Bluetooth
unit installed transceiver or an An-
®
droid
®
device (third party).
Bluetooth
connection image:
®
UT-133
Bluetooth
®
unit
installed
Transceiver
Bluetooth
®
VS-3
Bluetooth
mobile
®
device (third party)
Charging cautions
The charging time is approximately 3 hours.
If the LED does not turn OFF after 3 hours of charging,
disconnect the USB cable to stop charging.
Overcharge may degrade the battery performance or short-
en battery life. Also, it may cause a fire or explosion.
While charging, you cannot use the headset.
Connecting the earphone plug
Earphone plug
(3.5 (d) mm: 1 ⁄ 8 inch)
For your
For your
left ear
right ear
Using the earphones for a long time may
cause your ears to ache. We recommend
that you sometimes remove it while using.
-
Explicit definitions
head
®
opera-
®
WORD
R DANGER!
Personal death, serious injury or an explosion may occur.
R WARNING! Personal injury, fire hazard or electric shock may occur.
CAUTION
Equipment damage may occur.
Recommended for optimum use. No risk of personal in-
NOTE
jury, fire or electric shock.
Precautions
R DANGER! NEVER
ing a vehicle, except for a hands-free operation. Safe driving
requires your full attention—anything less may result in an
accident.
R DANGER! NEVER
atmosphere. This may pose a fire hazard or explosion.
R DANGER! NEVER
lithium polymer battery gas may cause it to rupture, or may
cause an explosion.
R DANGER! NEVER
oven or high-pressure cooker, or put on a electromagnetic
cooker. This may pose a fire hazard or explosion.
R DANGER! NEVER
eas with temperatures below –20°C (–4°F) or above +60°C
(+140°F). Extreme temperatures may damage the headset,
shorten the internal battery life, cause fluid to leak from the
battery, or cause the battery to rupture or catch fire.
R WARNING! NEVER
This may pose a fire hazard or result in an electric shock.
R WARNING! NEVER
tions to the headset. This may pose a fire hazard or result in
an electric shock.
R WARNING! NEVER
headset.
R WARNING! NEVER
hands to prevent electric shock.
R WARNING! NEVER
touch any internal part of the headset. This may result in an
electric shock or this could cause a fire or damage the head-
set.
R WARNING! NEVER
overcharge may cause overheating or battery may rupture.
CAUTION: NEVER
equipment. Radio waves the headset may cause the interfer-
ence.
CAUTION: NEVER
heat or remodel the USB cables and earphones.
This may result in an electric shock or this could cause a fire
or damage the headset.
CAUTION: NEVER
cable from the headset.
DEFINITION
CAUTION: NEVER
operate the headset while driv-
earphone jack is broken. Contact your Icom dealer or dis-
tributor for advice.
CAUTION:
Immediately stop the headset operation if it
emits an abnormal odor, sound or smoke. Contact your Icom
use the headset in an explosive
dealer or distributor for advice.
DO NOT
place the headset in excessively dusty environ-
incinerate the headset since the
ments or in direct sunlight.
DO NOT
use harsh solvents such as benzine or alcohol to
clean this device, as they will damage the device's surfaces.
put the headset in a microwave
If the device becomes dusty or dirty, wipe it clean with a soft,
dry cloth.
DO NOT
charge the headset outside of the specified tem-
use or leave the headset in ar-
perature range, 0˚C to +45˚C (32°F to +113°F).
If the headset must be left unused for a long time, it must be
kept safely in a cool dry place with the temperature range
as below:
–20˚C to +60˚C: –4°F to +140°F (within a month)
use a non specified USB cable.
–20˚C to +45˚C: –4°F to +113°F (within three months)
–20˚C to +25˚C: –4°F to +77°F (within a year)
After not using the headset for a long time, the internal bat-
make any changes or modifica-
tery may be completely exhausted. In that case, you may not
be able to charge it again.
Place the headset in a secure place to avoid inadvertent use
drop, impact or vibrate the
by children.
touch the headset with wet
let metal, wire or other objects
keep charging the battery since
The Bluetooth
on the environment in which the device operates.
use the headset nearby medical
Microwave ovens or wireless LAN may cause interference.
In that case, stop using those devices or move away from
them.
This Bluetooth
bend or slew around forcedly, hitch,
cation is unstable, use the device within the range.
Icom, Icom Inc. and the Icom logo are registered trademarks of Icom
Incorporated (Japan) in Japan, the United States, the United King-
dom, Germany, France, Spain, Russia and/or other countries.
hitch the cable when detaching the
The Bluetooth
®
owned by Bluetooth SIG, Inc. and any use of such marks by Icom
inc. is under license.
All other products or brands are registered trademarks or trade-
marks of their respective holders.
use the headset if the USB port or
communication range may vary, depending
®
device has a range of use. If the communi-
®
work mark and logos are registered trademarks
Need help?
Do you have a question about the VS-3 and is the answer not in the manual?
Questions and answers