Page 2
Furthermore, bhi Ltd. reserves the right to revise this publication and to make changes from time to time in the content hereof without obligation of bhi Ltd. to notify any person of such revision or changes. Page 2...
Page 3
To install this intercom you will need the following additional items: • CAT5 network cable/connections (straight-through). • Suitable fixings for mounting the loudspeaker • Suitable tools for installation of the above < page intentionally blank > Page 18 Page 3 NEIS-RM Intercom Operating Manual NEIS-RM Intercom Operating Manual...
The DSP levels are set by the following combination of jumpers. Desk console Operation Desk console controls Loudspeaker controls Noise cancellation level setting Table 2. Preset DSP levels using on board jumpers. Page 17 Page 4 NEIS-RM Intercom Operating Manual NEIS-RM Intercom Operating Manual...
Page 5
OFF. To reduce the risk of losing the jumper it is advised to place it on one pin when using the OFF position. Figure 10. Jumper details. Page 5 Page 16 NEIS-RM Intercom Operating Manual NEIS-RM Intercom Operating Manual...
Using minimal hardware components, the installation and operation of the bhi intercom system is very easy, connections being made via a single cat 5 data cable. The NEIS is pre-configured for optimum noise cancelling, and is fully adaptive to changing environmental conditions.
Release the switch and the noise will be removed. Adjust the volume control for a comfortable listening level. Page 14 Page 7 NEIS-RM Intercom Operating Manual NEIS-RM Intercom Operating Manual...
Before the power supply can be used, plug the pin unit supplied onto the power supply body until it clicks into place. Microphone Push pins onto power supply body Figure 4. Loudspeaker connections. Figure 3. Power supply. Page 10 Page 11 NEIS-RM Intercom Operating Manual NEIS-RM Intercom Operating Manual...
Need help?
Do you have a question about the NEIS-RM and is the answer not in the manual?
Questions and answers