Digital Effects - Kustom Sienna 35PRO User Manual

1.) Mic/Line Input - this is a 1/4" 2 conductor input jack for plugging in a Hi-Z microphone or instrument. It is intended for microphones
but will accept other instruments as well.
2.) Guitar Input - this is a 1/4" 2 conductor input jack for plugging in your instrument. It is intended for guitar or Hi-Z microphones but
will accept other instruments as well.
3.) Mic/Line Volume - this control is the output volume control for the mic/line input. Slowly increase the control to increase the
volume. If you are using a high impedance microphone, be careful when increasing the volume. Depending on mic position, it may
feedback if mic is in front of speaker.
4.) Mic/Line Input - this switch will select a mic or line level input. If you are using a high impedence microphone, be careful when
increasing volume. Depending on mic placement, feedback may occur.
5.) Guitar Volume - this control is the output volume control for the guitar input. Slowly increase the control to increase the volume. If
you are using a guitar with an on-board preamp, set it's level for a mid position before increasing this control otherwise distortion may
occur.
6.) Guitar Input- this switch will place a -20db pad in the circuit which will allow use of active on-board electronics from pre-amplified
guitars. This will help keep the signal extremely clean.
7.) Frequency - this control is a tight Hi-Q cut filter notch with an extremely narrow width. It sweeps between 50Hz & 500Hz and "fine
tunes" the midrange of the acoustic guitar. This helps eliminate unwanted "ringing" tones. It is preset to -10db.
8.) Low - this control is the bass control. It is active and set to boost or cut frequencies at 60 Hz. This will effect the low frequency
signals. Turning it counterclockwise, the low will be rolled off -18db. Clockwise, it will boost +18db. Especially good for "cleaning up"
preset patches or making thin toned guitars sound fuller.
9.) Mid - this control is the midrange control. It is active and set to boost or cut frequencies 1.5KHz. This will effect the mid-low
frequency signals. Turning it counterclockwise, the low-mids will be rolled off -12db. Clockwise, it will boost +12db. Especially good for
"cleaning up" guitar overtones.
10.) High - this is the high frequency tone control. It is active and set to boost or cut frequencies at 5KHz. This will effect the high
frequency signals. Turning it counterclockwise, the highs will be rolled off -18db. Clockwise, it will boost +18db. This will add or subtract
the high end shimmer and clarity.
11.) Effects On/Off - this switch engages the digital effects section.
13.) Effects Level - this control adds the digital effects section and mixes it into the main signal buss. Several different effects are
available.
13.) Program Select - this switch will select any of eight different effects. 3- Chorus, 4- Reverb, and 1- delay.
14.) Jewel Light - this jewel light lets you know that the amplifier is on.
15.) Power - this switch turns on and off the AC power to the amp.
Back Panel - (not pictured)
Speaker Out - this is a 2 conductor 1/4" speaker output jack. This will disconnect the internal speaker and allow an external speaker
cabinet to be employed. Rating is 8 ohms.
Line Output - this is a 2 conductor 1/4" line output jack. This will allow an external amplifier or mixing board to be supplied with the
signal from this amp. This signal is attenuated and comes from the power amp.
Headphone Jack - this is a three conductor 1/4"jack for plugging headphones. It will sum the signal and put the sound in both ears,
thereby creating a pseudo-stereo sound. Volume will be determined by the volume control on the channel you are on. It will disconnect
the internal speaker when plugged in. This will allow quiet practicing.
Footswitch- this is a three conductor 1/4" for connecting a footswitch to turn the Reverb and Chorus On and Off.
M o d e l
O u tpu t P o w e r
Eq u a liz e r
C h a n n e ls
Im pe da n c e
e c ts
A m pli e r T y pe
Dim e n s i o n s
Sienna 35PRO
30 W atts
4 Band
Two
8 Ohms
8 Presets
MOS-FET Transistor
mm/kg
Inches/Pounds
Acoustic guitar amplifier
8 Ohms @ 5 % THD
Digital E ffects
380 (Height) x 460 (W idth) x 245 (Depth), 14 kg
15 (Height) x 18.2 (W idth) x 9.7 (Depth), 31 lbs