Premaintenance Procedures; Raising The Seat; Accessing The Battery; Lubrication - Toro TimeCutter Z5020 74372 Operator's Manual

Premaintenance
Procedures

Raising the Seat

Make sure the motion control levers are locked in the
park position. Lift the seat forward and lower it to the
floor board.
The following components can be accessed by raising
the seat:
• Serial plate
• Service decal
• Seat adjustment knob
• Fuel filter
• Fuses
• Battery cables

Accessing the Battery

1. Raise the seat.
2. Remove the TORX ®
the left cover to the frame as shown in Figure 19.
2 2
3 3
Figure 19
1. Left cover
2. Torx head fasteners (25)
3. Lift the plastic cover away from the machine. Retain
all fasteners.
Replace the cover and secure it to the frame using the
fasteners removed previously.
head fasteners (25) securing
1
2
2
G005065
3. Battery

Lubrication

Greasing the Bearings

Service Interval: Every 25 hours—Grease all
lubrication points.
Grease Type: No. 2 General Purpose Lithium Base
Grease
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to the
park position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings (Figure 20 and Figure 21)
with a rag. Make sure to scrape any paint off of the
front of the fitting(s).
1. Front caster tire
Located on the seat pan underside
1. Read the instructions
before servicing or
performing maintenance.
2. Check tire pressure every
25 operating hours.
23
1
G005066
Figure 20
Figure 21
3. Grease every 25 operating
hours.
4. Engine