Sound Projections OPT-101 User Manual

Program Play

To program tracks on CD (not MP3)
1. Insert CD. Press PROG bu on to enter program mode.
2. Enter selected track by using the I
ton. Repeat un l all tracks are programmed.
(NOTE: When using the remote control for programming, selected tracks may be entered
directly by using the 0 through 9 numbers on the remote control keypad).
3. To play programed tracks, press PLAY bu on.
(NOTE: To return to normal play mode from program mode, press STOP bu on
followed by PLAY bu on. To return back to program mode press STOP bu on
followed by PROG bu on followed by PLAY bu on)
4. To clear programmed tracks, press PROG bu on followed by STOP bu on.
(NOTE: Programed tracks will be erased upon power off of the CD player)
To program MP3 tracks on CD or USB key
1. Insert CD or USB key. Press PROG bu on to enter program mode.
2. Press the I SKIP I bu ons to select folder. Press PROG bu on again fol-
lowed by I SKIP I bu ons for desired track followed by PROG bu on.
Repeat un l all tracks are programmed.
3. To play programed tracks, press PLAY bu on.
(NOTE: to return to normal play mode from program mode, press STOP bu on
followed by PLAY bu on. To return back to program mode press STOP bu on
followed by PROG bu on followed by PLAY bu on)
4. To clear programmed tracks, press PROG bu on followed by STOP bu on.
(NOTE: Programed tracks will be erased upon power off of the CD player)
ESP bu on (Electronic Shock Protec on, APPLIES TO CD ONLY)
The ESP bu on turns Electronic Shock Protec on off /on. ESP on is default.
(NOTE: Recommend to Always leave ESP set to "on")
ID3 bu on
(on remote control only)
Press ID3 bu on to display the tle, ar st, or album on upper display line. Tracks
without this program informa on may display nothing.
4
SKIP I bu ons followed by PROG but-
560-0031 Rev A opt-101 02/2013
www.soundprojec ons.com
User Guide
For OPT-101 CD/MP3-USB Player
1