Presto Big kettle Instructions Manual page 2

14. Do not let cord hang over edge of table or counter or touch hot surfaces.
15. Do not place on or near a hot gas or electric burner or in a heated oven.
16. Do not use appliance for other than intended use.
Important Cord and Plug Information
A short power supply cord (or cord set) is provided to reduce the risk resulting from becoming entangled in or tripping over a longer
cord. DO NOT USE WITH AN EXTENSION CORD.
Do not allow the cord to run underneath or around the unit. The magnetic cord may not detach easily if the cord is positioned in this fashion.
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit
into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician. Do not attempt to modify the plug in any way.
Connect the power supply cord to a 120VAC electrical outlet only.
How to Install Legs and Handles
Tools Required: Phillips type screwdriver
To Install Legs to Base
1. Place multi-cooker upside down on table or counter.
2. Using the screwdriver, remove the screws from each of the four mounting projections on the bottom of the unit. These screws are
for attaching the legs to the multi-cooker base.
3. Position one of the legs, with the rubber insert facing up, over one of the mounting projections (Fig. A). Align the hole in the leg with
the hole in the mounting projection and fasten securely with screw. Leg should not rock or move if twisted. NOTICE: Overtightening
can result in stripping of screws or cracking of legs.
4. Repeat step 3 for the other three legs.
5. Turn multi-cooker right side up on table or counter. When properly assembled, the multi-cooker should sit level with no leg rock.
To Attach Handles to Base
1. With multi-cooker upside down on table or counter, remove the screws from
the tabs on each side of the multi-cooker base. These screws are for attach-
ing the handles to the base. Hint: When removing the screw under the plug
guard, hold the screwdriver at a slight angle or use a short screwdriver or a
screwdriver with a long shank.
2. Slide one of the handles, with the screw hole facing up, onto the tab so the
screw hole on the tab aligns with the screw hole on the handle (Fig. A).
Fasten with screw and tighten fully. Handle should not wobble, but slight
movement from side to side is normal. NOTICE: Overtightening can result
in stripping of screws or cracking of handles.
3. Repeat step 2 for the other handle.
4. When properly installed, the handles should appear parallel with the table
or counter.
To Attach Basket Handle
1. Slide lock bar up on handle (Fig. B) and place one of the
handle bars into one of the tabs on bracket. Then squeeze
the handle bars together and fit the other handle bar into
the opposite tab on bracket.
2. After attaching handle to basket, make sure to slide the
lock bar down (Fig. C) to the locked position to insure
against accidental detachment of handle from basket.
SAVE THESE INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE ONLY.
Parts Included: 4 Legs
2 Handles
Fig. A
Leg
Mounting
projection
Tab
Fig. B
Lock
bar
Handle
bar
2
Screw
Handle
Fig. C
Lock bar
Tab
Rubber
insert
Plug
guard
Screw
Screw
hole
Tab