Sceptre E485 User Manual page 49

Problems
WEAK SIGNAL OR
NO PROGRAM
SYMBOL ON
SCREEN
TV'S UNIVERSAL
REMOTE CODE
TV CHANNELS ARE
BLOCKED
UNIVERSAL
REMOTE CODE
THE TV TURNS ON
OR OFF SLOWLY
AND THE SCREEN
SHOWS UP
SLOWLY
NO SOUND ON PC Make sure you have a 3.5 mm mini-jack cable connected from
HDCP VIDEO SAYS
NO HDCP SUPPORT
HDCP VIDEO HAS
NO AUDIO
CANNOT GET
1920X1080 ON PC
VGA
PICTURE IS
DISTORTED OR
HAS ABNORMAL
SOUND
PICTURE DOES
NOT COVER THE
ENTIRE SCREEN
The TV's tuner signal must not be lower than 65 %. Check your
signal.
The TV's tuner signal must not be lower than 65 %. Change
the direction of your antenna and rescan your channels. If you
have cable call up your cable company and ask about signal
strength of your local cable.
This television follows SONY's universal remote code. To find
the actual code you must read through your own universal
remote's guide book.
Check your auto lock function's settings inside the OSD. You
may have locked up some channels but forgot about them.
Refer to page 33 for more instructions.
This TV follows SONY's universal remote code. Please check
your hand book for SONY's codes then apply them.
This TV is a High Definition liquid crystal display panel TV. It
requires a few more seconds than normal TVs to power up and
show the picture.
your pc's sound output to the TV's VGA STEREO INPUT.
Reboot your HDCP video device but turning them off and
unplugging the power cord. Wait up to 8 minutes to plug the
power back in to see if it works or not.
Make sure you have a 3.5 mm mini-jack cable connected from
your HDCP video device's sound output to the TV's VGA
STEREO INPUT. If your HDCP video device uses RCA AUDIO
jacks, you'll need to obtain a RCA audio converted into 3.5 mm
mini-jack cable.
Make sure the TV is recognized as plug and play monitor. Try
updating your video card's drivers as well. If that does not help,
most likely you'll need to upgrade your video card to a newer
one.
This might be from interference from large electrical appliances,
cars, motorcycles, or fluorescent lights. If the TV is close to the
wall, try moving the TV to another room in your house to see if
the problem still occurs.
If you're using HDMI or a TV digital channel make sure you use
the ASPECT button to switch to 16:9 format. If you are using
VGA, use the AUTO ADJUST function to adjust to the screen.
Please Note : If you are using regular analog TV, AV, or
component in 480i resolution, use the ASPECT button to switch
to 16:9 in order to fill up the screen. Please Note : This note
this feature will distort the picture.
- 49 -
www.SCEPTRE.com
SCEPTRE E485 HDTV User Manual
Solutions