Advertisement
Quick Links
MGS200 Installation Guide:
Contents:
1.
MGS200-G
2.
Antenna pad
3.
20 pin cable
4.
Antenna
5.
Blue ring terminal (gound connector)
6.
Fuse holder
7.
Amp fuse
8.
Plated steel screws
1.
MGS200 Installation Guide
Confidential Version 1.4
1. Contents
2. Tools / Materials required
2. Work order / System outline
2. Hardware location and preparation
3. Antenna location
3. MGS mounting
4. Power wire installation
5. Wire connections
& fusing
6. Installation diagram
2.
3.
Feb, 10
6.
8. 7. 5.
4.
Advertisement
Summary of Contents for Fleet Complete MGS200
- Page 1 MGS200 Installation Guide Feb, 10 Confidential Version 1.4 MGS200 Installation Guide: 1. Contents 2. Tools / Materials required 2. Work order / System outline 2. Hardware location and preparation 3. Antenna location 3. MGS mounting 4. Power wire installation 5. Wire connections &...
-
Page 2: Tools Required
MGS200 Installation Guide Feb, 10 Confidential Version 1.4 Page Tools Required: Hardware location and preparation: Full compliment of various screw Note: It is important to insulate the wires not being used on drivers the wire harness during the installation. Improper insulation... -
Page 3: Antenna Location
MGS200 Installation Guide Feb, 10 Confidential Version 1.4 Page MGS mounting: Antenna location: Note: The GPS/RF Combo antenna must be mounted flat with Note: The unit should be mounted so it will not be exposed to the GPS Receiver facing up (The letter “H” is facing up). The damage from people or objects. - Page 4 MGS200 Installation Guide Feb, 10 Confidential Version 1.4 Page Power wire installation: The MGS is connected directly to the vehicle’s 12-volt system. Splice the other side of the fuse holder to the power wire • There is no on-off switch on the unit. The installed unit oper- identified in the vehicle with solder or crimp terminal.
- Page 5 MGS200 Installation Guide Feb, 10 Confidential Version 1.4 Page Red LED Description Confirming proper operation: No faults detected License Key Exp. • Connect the antenna cables to the appropriate locations 1 – 1 on the MGS. CDMA Module fault 2 – 1 Not Activated 2 –...
- Page 6 Applies to Serial # 000003260000 (+) When the ignition is first turned on the MGS200 will power-up. The Green LED will show solid for approximately 30 seconds. At no other time should be green LED remain on solid for such a long period.
Need help?
Do you have a question about the MGS200 and is the answer not in the manual?
Questions and answers