Summary of Contents for Solwise PLA-AV-3E-PIGGY6
- Page 1 User Manual PLA-AV-3E-PIGGY6 HomePlug AV 3 Ethernet Ports with 6-Outlet Power Strip Ver. 1.0 03/10/08...
- Page 2 (1) This device may not cause harmful interference (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment is in compliance with the requirements of the following regulations: CE Mark, 89/336/EEC RoHS This product is RoHS compliant. VeseNET, www.vesenet.co.uk...
-
Page 3: Table Of Contents
Table of Contents HOMEPLUG POWERLINE..........................4 ...............................4 NTRODUCTION ............................4 SAGE IAGRAM ............................4 HYSICAL ETAILS ................................6 ETUP SECURITY BUTTON ............................7 AB) ....................7 REATING A NEW SECURITY NETWORK ETWORK OPERATION ............................... 9 SPECIFICATION............................... 10 VeseNET, www.vesenet.co.uk... -
Page 4: Homeplug Powerline
Internet connection. 1.1 Introduction The PLA-AV-3E-PIGGY6 (Piggy6) allows you to connect up to 3 devices which have Ethernet ports to a Powerline network. At the same time, the 6 outlet extension provides 6 filtered power plugs allowing multiple devices to plug in for power and filters them so they do not affect the performance of the built-in HomePlug 200M 3 Ethernet ports. - Page 5 This button is used to clear ALL data and restore ALL settings to the factory default val- ues. Press and release the reset button to begin restore factory default. Rear Panel The rear panel contains three LAN Ethernet Ports. VeseNET, www.vesenet.co.uk...
-
Page 6: Setup
2. Connect the Piggy6 to your devices. 3. Wait a few seconds for startup to be completed, and then check the LEDs The Power LED should be ON. The HomePlug LED will be ON 4. Hardware Installation is now completed, enjoy HomePlug Powerline connectivity. VeseNET, www.vesenet.co.uk... -
Page 7: Security Button
Adapter B for 2 seconds then release. 7. Both Adapter A and Adapter B are now networked together. Adding Adapter C to existing Network AB (Adapter A and Adapter B) One unassociated Adapter C is added to an existing Network AB. VeseNET, www.vesenet.co.uk... - Page 8 3. Within 120 seconds after the Power LED on Adapter D starts to flash, press and hold the security button on Adapter B for 2 seconds then release. 4. Adapter B and Adapter D are now connected to each other, which in turn becomes part of Network BDE. VeseNET, www.vesenet.co.uk...
-
Page 9: Operation
Use a pin and hold the Reset Button down for two seconds on each unit you are trying to connect. The unit lights should flash. Then units will then connect based off factory settings. Piggy6 works better when plugged directly into the wall socket. Connecting the Piggy6 into the power strip or surge protectors may degrade the network performance. VeseNET, www.vesenet.co.uk... -
Page 10: Specification
0 C to 40 C Storage Temperature -20 C to 70 C Operating Humidity 10-90%RH (max) Hardware Operating Sys- Windows Vista, Windows 2000, Windows XP, Linux, Mac OS X or any other tems operating system with network support VeseNET, www.vesenet.co.uk...
Need help?
Do you have a question about the PLA-AV-3E-PIGGY6 and is the answer not in the manual?
Questions and answers