Clean Your Electric Hot Water Dispenser Before First Use; Using Your Electric Hot Water Dispenser - Oster BVSTWD7915 Series User Manual

Clean your electric Hot Water Dispenser before first use

1. Wash the inside of the Hot Water Dispenser and lid with mild
detergent and water. Rinse each thoroughly. Do not immerse the Hot
Water Dispenser or power base in water or any other liquid. These
items are not dishwasher safe.
2. Fill the water tank with fresh water to the "MAX" water level. Boil
the water, following the directions below for use of your Hot Water
Dispenser.
3. When the water and unit have cooled, discard the water. Rinse with
cold water and repeat.
4. Your electric Hot Water Dispenser is now ready for use.

Using your Electric Hot Water Dispenser

1. Position the power base on a flat, heat resistant surface, as close as
possible to a power outlet.
2. Follow cord routing in power base according to exit patterns.
Proper cord routing will result in the power base laying flat when
Hot Water Dispenser is placed on base. DO not operate Hot Water
Dispenser if power base is not flat. If power base is not flat, remove
Hot Water Dispenser from power base and repeat cord placement
instructions.
3. To fill with water, open the lid by pressing the lid release button.
Fill the water tank with water to below the "MAX" water level
mark. Ensure the lid is firmly closed in place before plugging the
Hot Water Dispenser into the electric outlet. NOTE: Do not exceed
the "MAX" water level mark indicated on the electric Hot Water
Dispenser. The water level must be within the "MAX" and "MIN"
level as too little water will not allow the Hot Water Dispenser to
dispense water into the container, instead the boil dry safety shut-off
feature will activate.
5