Advertisement
Advertisement
Table of Contents
Summary of Contents for Magnum ST-2
- Page 1 ST-2 Vertical, Omni-Directional, ½ Wave Antenna INSTALLATION INSTRUCTIONS...
- Page 2 If the ST-2 arrived disassembled, or if the whip was found to be loose during the above test, carry out the following procedure. Using a 3/8” open end wrench, loosen the gold locking nut at the top of the coil assembly.
- Page 3 TV masts etc. The ST-2 may be installed atop your TV mast without bothering the receptive capability of your TV antenna. Simply fasten the ‘L’ bracket to the mast using two outdoor-type (stainless steel) hose clamps.
- Page 4 NOTE: For best results, you must use cable with the exact same specification as the cable already in use. For example, ‘RG59/U’ cable is normally supplied with the ST-2. If you wish to extend this cable, you must use only ‘RG59/U’. Do not use cable that is labeled ‘RG59/U type’.
Need help?
Do you have a question about the ST-2 and is the answer not in the manual?
Questions and answers