Table of Contents
Advertisement
Quick Links
Electronic Service
Manuals
This electronic document is provided as a service to our customers.
We do not create the contents of the information contained in this docu-
ment. Should you have detailed questions pertaining to the information
contained in this document, you may contact Michco, or the manufac-
turer which provided the original information in this electronic deliver-
able. Michco's only part in this electronic deliverable was the electronic
assembly process. By providing this manual on line we are not guaran-
teeing parts availability.
You may contact Michco through the following methods:
Phone (517) 484-9312 or (800) 331-3339
2011 N. High St. -- Lansing, Michigan -- 48906
Fax: (517) 484-9836
Email: CustServe@Michco.com
Web site: www.Michco.Com
Parts Web site: www.FloorMachineParts.Com
Order Parts on Line at:
www.FloorMachineParts.Com
Directly to Parts & Service:
By Email:
Shop@Michco.com
By Fax: (517) 702-2041
By Voice: Use numbers above.
Serving the Cleaning Industry Since 1922
Notice: All copyrighted material remains property of original owners, all trademarks are property of respective owners.
Manuals are subject to Manufacturer's reproduction limitations. Originals or reproductions were provided by manufacturers
through a request. We make no warranty as to the correctness of information provided in this document and you assume
all risk. By placing these manuals on line we are not declaring our corporation to be an manufacturer authorized dealer or
provider, please check our web site for authorized manufacturers we represent.
Advertisement
Table of Contents
Related Manuals for Clarke PB-12
Summary of Contents for Clarke PB-12
- Page 1 Electronic Service Manuals This electronic document is provided as a service to our customers. We do not create the contents of the information contained in this docu- ment. Should you have detailed questions pertaining to the information contained in this document, you may contact Michco, or the manufac- turer which provided the original information in this electronic deliver- able.
- Page 2 English, have this manual explained fully before attempting to operate this machine. All directions given in this book are as seen from the operator’s position at the rear of the machine. For new books write to: ALTO U.S. Inc., 2100 Highway 265, Springdale, Arkansas 72764. Form No. 78010C...
-
Page 3: Table Of Contents
How to do Maintenance After Each Use of Machine ............13 Upper Unit Drawing .......................... 16 Parts List ..........................17 Lower Unit Drawing ......................... 18 Parts List ..........................19 Wiring Diagram 120V ........................20 Wiring Diagram 230V ........................21 CLARKE TECHNOLOGY PB-12 Operator's Manual Page 2... -
Page 4: Operator Safety Instructions
Any alterations or modifications of this machine could result in damage to the machine or injury to the operator or other bystanders. Alterations or modifications not authorized by the manufacturer voids any and all warranties and liabilities. CLARKE TECHNOLOGY PB-12 Operator's Manual Page 3... -
Page 5: Introduction
INTRODUCTION Model PB-12 Power Brush Tool NOTE: In this book, "machine" and "power brush tool" mean the Model PB-12. "Extractor" means another machine that gives the solution and vacuum. NOTE: When using the PB-12 and the extractor to clean carpets, follow this procedure. -
Page 6: How To Assemble The Machine
Figure 2 7. Close the cover. Put the lever in the locking position. 8. Install the cotter pin. See figure 4. 9.Remove the locking cam from the plastic bag. Figure 3 Figure 4 CLARKE TECHNOLOGY PB-12 Operator's Manual Page 5... - Page 7 14. Install the solution hose around the outside of the handle to the fitting on the handle tube. See figure 8. 15. Install the vacuum hose. See figure 9. Figure 7 Figure 9 Figure 8 CLARKE TECHNOLOGY PB-12 Operator's Manual Page 6...
-
Page 8: Machine Controls
When the brush comes in contact with the carpet, push the 1. The Lever 2. The Settings adjustment lever in the detent. Figure 12 CAUTION: Be careful when cleaning long shag. The carpet can go around the brush, and slow and stop the CLARKE TECHNOLOGY PB-12 Operator's Manual Page 7... -
Page 9: How To Connect The Hoses
2. Lower the handle to the best operating position. NOTE: For best operation, raise the handle until the wheels are just above the floor. Keep your back Figure 14 straight. 3. Using your foot, push the locking lever down. See figure CLARKE TECHNOLOGY PB-12 Operator's Manual Page 8... -
Page 10: Instruction For Connection To The Power Supply And Electrical Ground
Do not use an extension cord The machine has a power cord with wire size 14 AWG (AWG longer than 50 feet. Do not means American Wire Gauge). join two extension cords. CLARKE TECHNOLOGY PB-12 Operator's Manual Page 9... - Page 11 Use only an approved extension cord with two main conduc- make the connection. tors and one earthing conductor. The machine has a power cord with wire size 1.5mm CLARKE TECHNOLOGY PB-12 Operator's Manual Page 10...
-
Page 12: How To Operate The Machine
4. Lift the cover of the machine. 5. Turn the machine so that the right side is up. 6. Remove the two screws that fasten the brush. Figure 17 7. Remove the brush. CLARKE TECHNOLOGY PB-12 Operator's Manual Page 11... -
Page 13: How To Install The Brush
13. Turn the machine so that the left side is up. 14. Remove the two pins from the brush housing plate. 15. Remove the plate. 16. Remove the bolt that holds the pulley. 17. Remove the pulley and the belt. Figure 20 CLARKE TECHNOLOGY PB-12 Operator's Manual Page 12... -
Page 14: How To Install The Brush Drive Belt
See figure 23 8. Check for leaks at all connections. CAUTION: To prevent damage to the spray jet, do not push a wire or other object through the opening in the jet. CLARKE TECHNOLOGY PB-12 Operator's Manual Page 13... - Page 15 WARNING: Electrical repairs must be done by au- thorized personnel only. WARNING: After electrical repairs are done to the machine, the machine must be tested for electrical safety. For electrical repairs, return this machine to a Clarke Authorized Repair Center. CLARKE TECHNOLOGY PB-12 Operator's Manual Page 14...
- Page 16 NOTES CLARKE TECHNOLOGY PB-12 Operator's Manual Page 15...
-
Page 17: Upper Unit Drawing 1/02
CLARKE TECHNOLOGY Model PB-12 Upper Unit Drawing 1/02 CLARKE TECHNOLOGY PB-12 Operator's Manual Page 16... -
Page 18: Parts List
Pin, Handle, Tongue, Pivot 930005 Rivet, 47711A Terminal, .25 FIFQDC 449061 Tube, Handle Support 899254 Tie, Wire 35232A Housing, Switch Front NOTE: indicates a change has been made since the last publication of this manual. CLARKE TECHNOLOGY PB-12 Operator's Manual Page 17... -
Page 19: Lower Unit Drawing 1/02
CLARKE TECHNOLOGY Model PB-12 Lower Unit Drawing 1/02 CLARKE TECHNOLOGY PB-12 Operator's Manual Page 18... -
Page 20: Parts List
16283A KIt, Literature 53601A* Elbow, 90 722021 Clamp, Hose 36500B Manifold, 12" Asm. *NOTE: Included with item # 44. NOTE: indicates a change has been made since the last publication of this manual. CLARKE TECHNOLOGY PB-12 Operator's Manual Page 19... -
Page 21: Wiring Diagram 120V
CLARKE TECHNOLOGY Model PB-12 120 Volt Wiring Diagram 4/95 CLARKE TECHNOLOGY PB-12 Operator's Manual Page 20... -
Page 22: Wiring Diagram 230V
CLARKE TECHNOLOGY Model PB-12 230 Volt Wiring Diagram 4/95 CLARKE TECHNOLOGY PB-12 Operator's Manual Page 21... - Page 23 NOTES...
- Page 24 Springdale, Arkansas 72764 (501) 750-1000 Customer Service - 1-800-253-0367 SALES SUBSIDIARIES Technical Service - 1-800-356-7274 ALTO Canada Ltd., Rexdale Ontario ALTO U.S. Inc., Bowling Green, Ohio 43402 24 Constellation Ct. 1100 Haskins (416) 675-5830 ALTO Overseas Inc., Sydney (Australia) 1B/8 Resolution Drive...
- Page 25 Clarke product. Return the card to assist Clarke in providing the performance you expect from your new floor machine. ALTO U.S. INC., 2100 Highway 265, Springdale, Arkansas 72764. CLARKE TECHNOLOGY reserves the right to make changes or improvements to its machine without notice.
Need help?
Do you have a question about the PB-12 and is the answer not in the manual?
Questions and answers