Automatic Safety Cut-Off; Cleaning And Maintenance - Heaven Fresh HF 1110 Instruction Manual

AUTOMATIC SAFETY CUT-OFF

An automatic safety is itted to the kettle for protection against boil-dry overheating. It
will operate if the kettle is switched ON when there is insuficient water inside the kettle
(i.e. the kettle is not above the MIN marking). If this should occur, switch the kettle OFF
and remove the power cord from the power outlet. Allow cooling for 10 minutes then reill
with cold water and reconnect to the power outlet.

CLEANING AND MAINTENANCE

1. Make sure the product is turned OFF and DISCONNECTED from the power
outlet. Let the product cool down before cleaning.
2. Clean the exterior of the product by wiping with a slightly dampened (not wet)
soft cloth. Remove stubborn spots with a cloth moistened (not wet) with sudsy
water or mild, non- abrasive cleaner. Avoid the use of scouring pads, harsh
detergents, solvents, polish, abrasive or aerosol cleaners as they may damage
surfaces of the product. Dry with a clean, soft cloth before storage, or
reconnecting to the power outlet.
From time to time, depending on the nature of your water supply, you may need
to clean the inside of the kettle. This can be done in the following manner:
1. Half ill the kettle with normal tap water.
2. Add 30 ml of while vinegar to the water in the kettle.
3. Boil the mixture and leave it for 1 to 2 minutes, then re-boil it once more.
NOTE: In extreme cases this process may need to be repeated.
IMPORTANT
Empty the mixture in kettle and thoroughly rinse several times before normal use.
WARNING
The use of descalers containing phosphoric acid, sulfamic acid, or their equivalents must
not be used as they may damage your kettle.
Heaven Fresh 5 HF 1110