Recording Cd Tracks Onto Md In Desired Sequence - Kenwood MDX-G2 Instruction Manual

Recording onto MD (continued)
With regards to track numbers at
the time of recording
MD track numbers are used to search the
beginning of a track or programming tracks.
÷ In MD recording from the radio, AUX or
CD source, track numbers are assigned
automatically in the following cases.
– When the MD 6 or MD REC key is
pressed in record-pause mode to
resume recording.
– When the MD EDIT key on the remote
is pressed during recording.
30 EN
Recording CD tracks onto
MD in desired sequence
The tracks in a CD can be recorded by rear-
ranging them in the desired sequence when
the recording speed is normal (CD=MD
NORM). Note that this function is not avail-
able when the recording speed is high
(CD=MD HIGH).
MD O.T.E.
7 STOP
Remote control unit only
1
Make preparation for recording.
MD : See steps 1 to 3 of "Recording
CD onto MD" (page 16).
2
Program the CD tracks in the de-
sired sequence.
See steps 1 to 5 of "Playing CD or
MD tracks in the desired sequence"
(page 23).
3
Start recording.
Recording onto MD : Press the MD
O.T.E. key.
To stop recording :
Press the 7STOP key.
÷ Be careful not to switch the power off or ap-
ply shock or vibrations to the system while
"MD WRITING" is displayed.
÷ When recording with high volume, sound
skip may occur during MD playback. To avoid
this problem, reduce the volume during re-
cording.
MD O.T.E. SLEEP POWER
6 6
FM / AM CD MD
P. CALL P. CALL
7
4 ¢
STOP
fi %
TUNING
TUNING
¡
1
VOL.