Advertisement
5. Remove the upper inboard speaker screw from the right-
side J&M 7.25" speaker. (Figure C) If you are using 5.25"
speakers, remove the top speaker screw from the right-side
speaker. (Figure D)
6. Choose the correct upper amplifier mounting bracket for
the size speakers you are using. (Figure E)
7. Install the bracket into the fairing using the (2) longer
Allen-head bolts provided and the previously removed
speaker screw. (Figure F) If using 5.25" speakers, use of
the provided longer self-tapping speaker screw is required.
(Figure G)
8. Using (2) of the 6-32 screws, washers, and lock-nuts
provided, attach the lower amplifier mounting bracket to the
amplifier. (Figure H) Do not tighten hardware at this time.
9. Using the (2) remaining 6-32 screws, washers, and
lock-nuts, attach the amplifier to the already installed upper
mounting bracket. (Figure I) Attach the lower mounting
bracket to the lower right hand fairing mounting stud.
(Figure J) Position the amplifier upward as much as
possible and tighten all hardware.
Fig. E
7.25" speaker
Fig. G
5.25" speaker
Fig. C
remove
7.25" speaker
Fig. D
Fig. F
Fig. H
remove
5.25" speaker
Advertisement
