Table of Contents
Advertisement
Cleaning The Inlet Filter
WARNING: Check whether dangerous chemicals have
been used and take precautions when handling filters.
A.) Unscrew clear tube by hand.
B.) Remove Inlet filter
C.) Run water though to clean filter
Checking the Tire Air Pressure
A.) Remove air fill cap
B.) Fill tire to 20psi (1.4bar)
C.) Replace air fill cap
Air Fill Stem
Air Fill Cap
Burner Fuel Filter
Drain water which has accumulated in the fuel filter
bowl and replace the filter as needed.
Checking the Hoses
WARNING: Do not use a finger or skin to check for
leaks. Escaping fluid under pressure has sufficient
force to penetrate the skin, causing serious injury. Do
not operate the pressure washer if the hose is cracked,
worn or leaking.
FIG02300
Changing The Pump Oil
*Change oil after first 50 hours, then every 3 months or 500
hours
1.) Remove oil drain plug
2.) Drain pump oil.
3.) Replace oil drain plug.
4.) Fill pump oil according to table below.
5.) Use sight glass to fill to proper level.
Pump
CAT
Filter
Filter
Water Drain
Water Drain
A.) Check all hoses for leaks
Good
Bad
Water
Bad
Wire Mesh
B.) Check all hoses of worn areas
Quantities Of Fluid
Type of Fluid
SAE 30**
*
*
Non-Detergent Oil (order pump oil Item #22158)
Oil Fill
QTY
8.5 oz (0.25L)
Cat
Pump
Oil Drain Plug
(Underneath)
14
Advertisement
Table of Contents
